Doug for Model Number GHW9300PW4 My washer runs about 8 minutes or so into a new cycle then generates an HF or FH error and drains the machine and will not complete the wash. I was told to replace the flowmeter but this model does not have one. It looks like it utilizes a fill valve/solenoid assembly and I need to get this running. Wife is upset as we have been without a washer for almost a week and laundry is piling up. What can I check next?
Answer Doug, The FH error code indicates that there is no water detected entering the machine or the pressure switch trip not detected. You will want to check the following: Possible Causes / Procedure ¦ If there is no water in the unit: —Make sure that both valves at the water source(s) are turned on all the way. —Check for plugged or kinked inlet hoses or plugged screens in the inlet valves. —Verify inlet valve operation. ¦ If there is water in the unit: —Verify drain pump operation. —Verify that the pressure switch hose is in good condition and properly connected to tub and pressure switch. 1. Verify there is not a siphon problem. 2. Unplug washer or disconnect power. 3. Verify wire harness connections to inlet valves, pressure switch, drain pump, flow meter, and Central Control Unit (CCU). 4. Check all hoses for possible leaks. 5. Plug in washer or reconnect power. 6. Verify pressure switch operation. 7. Verify flow meter operation by blowing air through the part and measuring the resistance. 8. Verify CCU operation by running a Diagnostic test or any cycle. Read More... Answered by AppliancePartsPros.com | Friday, April 26, 2013