Parts for Kitchenaid 5KSB1585BVB0: Attachment Parts

This 60-oz blender jar assembly replaces a damaged or worn jar so you can safely blend full batches again. It provides a secure container for ingredients and a proper fit on the base for consistent, mess-reducing performance. What it does:

• Provides a 60-ounce container for blending, mixing, and pouring
• Interfaces with the blender base for efficient circulation of ingredients
• Helps prevent leaks when the jar and sealing surfaces are intact
• Typical symptoms of a bad jar: cracks, leaks, clouding, or an unstable fit on the base

• One 60-oz blender jar assembly

• Unplug the blender before servicing
• Remove the old jar; if your model uses a separate blade/collar, ensure gaskets are properly seated during reassembly
• Wash the new jar before first use and confirm it seats flat on the base
• Fill with water and test for leaks before blending food

A replacement shim that restores correct spacing and alignment between appliance components to reduce vibration and rubbing. Helps ensure parts fit together properly after repair or during reassembly. What it does:

• Provides precise spacing and alignment between panels, brackets, or assemblies
• Helps reduce noise and vibration caused by parts rubbing or sitting out of alignment
• Used when reseating or replacing components to maintain proper clearances
• Small, simple part that supports reliable operation of surrounding hardware

• Disconnect power to the appliance before starting any repair
• Install in the same location and orientation as the original shim; retain any removed fasteners
• Use basic hand tools; avoid forcing parts—check alignment as you tighten
• Refer to the manufacturer's service manual or parts diagram for exact placement and torque guidance

This replacement coupling links and seals wash-system components so pressurized water reaches the spray arms. Replacing a cracked or worn coupling restores cleaning performance and helps prevent drips at the connection point.

• Provides a secure, watertight connection within the dishwasher wash system
• Helps deliver proper water flow to the spray arms
• Failure symptoms can include poor cleaning, spray arms not turning, a loose/detached feed tube, or leaks at the connection
• Replace if the coupling is cracked, deformed, or stripped

• Disconnect power and shut off water before servicing
• Remove dish racks and access the coupling at the manifold/feed-tube area per your model
• Inspect existing seals/O-rings and replace if worn
• Seat and lock the coupling fully; run a short cycle to check for leaks