Parts for Frigidaire FEF450WCDC: 02 - Backguard Parts

This selector switch controls the various heat or function settings on the range, allowing you to choose between different cooking modes or burner configurations. It mounts behind the control panel and connects to the wiring harness. Replace this switch if it fails to change settings properly, the knob turns without engaging, or the range does not respond when switching between functions.

Replace your range oven indicator light bulb when it burns out or dims. Restores visibility of oven status and control panel illumination. Verify fit with your model number before ordering.

The Rocker Switch is an OEM part for Frigidaire ranges and ovens. It is responsible for turning the interior oven light on and off. The light switch allows visibility of the oven cavity for viewing food during the cooking process.

Causes can include normal wear and tear over time, exposure to heat inside the oven cavity, or accidental damage.

Symptoms of a bad oven light rocker switch include:

• The oven light failing to illuminate when the door is opened
• The light remaining on even when the door is closed
• An inconsistent or flickering oven light
• The switch itself becoming loose, cracked, or non-responsive

This OEM Frigidaire part is also compatible with Electrolux, Gibson, Kelvinator and some Kenmore models.

Replacement #8 x 0.500 inch screw for securing panels, trim, and brackets in appliances. Needed when original fasteners are stripped, lost, or missing.

Replacement machine screw used to secure appliance panels and internal components, restoring a stable fit and reducing rattling. Matches a 10-32 thread with a 17/32-inch length for original fastener locations. What it does:

• Fastens panels, trim pieces, and internal brackets; a missing or damaged screw can cause loose panels or rattling noises.
• Secures knobs, control housings and small assemblies to prevent wobble or misalignment.
• Restores proper fit for components so doors and access panels sit evenly and function reliably.

• Disconnect power (unplug or shut off circuit) before accessing components.
• Use the correct driver and tighten by hand; avoid overtightening to prevent stripped threads or cracked plastic.
• Keep any original washers or clips and reinstall them with the screw.

This door retainer secures the door trim and inner door components to keep the appliance door aligned and stable. It restores proper door fit and prevents loose or rattling trim for safer, quieter operation. What it does

• Holds door trim/inner panel in place so the door closes and seals correctly
• Stops loose or vibrating trim that can cause noise or uneven gaps
• Helps maintain proper alignment to reduce strain on hinges and latches
• Common symptom: loose, misaligned, or rattling door trim

• One door retainer

• Disconnect power (or unplug) before starting any repair
• Remove door trim or inner panel per service instructions to access retainer
• Install the retainer in the same orientation; secure with the original fasteners

Mounting plate that secures the power cord set to the back of your range. Replace if the original plate is cracked, broken, or missing during installation.

Rubber grommet plug that seals the light switch opening in your range control panel. Replace if cracked, torn, missing, or no longer providing a tight seal.

Replacement #8 x 0.500 inch screw for securing panels, trim, and brackets in appliances. Needed when original fasteners are stripped, lost, or missing.