Parts for Frigidaire FGDS3065KFA: 03 - Backguard Parts

This genuine replacement part is an oven control board. The oven control board is the main circuit board that controls the ovens' essential functions. If the oven isn't heating properly, not turning on, or showing an error code on the digital display, it might be time to replace the control board. Replacing a control board may seem like a difficult task, but it is a relatively simple process. Start by unplugging the range. After that, move the appliance back to gain access to the back. Remove the upper back panel, and locate the control board. Take note of the orientation of the wires using a phone camera. Then detach the wire harness from the old control board. Remove any individual wires with needle-nose pliers. Then reattach the wires to the new control board in the correct terminals. Snap the new control board into place and reinstall the upper back panel of the range.This OEM replacement part is compatible with Frigidaire, Electrolux, Gibson, Kelvinator, and Westinghouse brand ovens.

This wiring harness provides the factory-style electrical connections needed to restore secure, routed wiring between appliance components. It replaces a damaged or worn harness to help re-establish reliable circuit continuity. What it does

• Carries electrical signals and power between internal components to enable normal appliance operation
• Restores connection when cracked insulation, broken wires, or damaged terminals cause intermittent power or component failure
• Prevents shorts and erratic behavior by replacing chafed or corroded wiring
• Matches OEM connector types to ensure proper fit and secure mating with factory plugs

• Disconnect power (unplug appliance or shut off breaker) before starting any repair
• Compare new harness to the original to ensure connectors, length, and mounting points match
• Route harness along the original path and secure with existing clips or ties to avoid heat or abrasion

This replacement screw secures appliance panels, brackets, and internal components. It restores a tight, rattle-free fit and proper alignment when an original fastener is missing, stripped, or corroded.

• Fastens metal or plastic parts to the cabinet/frame
• Helps maintain alignment and reduce vibration or rattling
• Direct replacement for lost, damaged, or rusted hardware
• Keeps covers and brackets safely in place

• Disconnect power before servicing; for gas appliances, also shut off gas supply
• Match one-for-one with the original screw; verify length/type before installation
• Start threads by hand to avoid cross-threading; tighten snugly without overtightening
• Use the correct driver bit to prevent stripping the screw head