Parts for Frigidaire FGGF304DLF2: 03 - Backguard Parts

Gas burners won't ignite and there's no clicking sound? The spark module provides the electrical spark to light all burners. DIY repair in under 1 hour.

Replacement bracket for gas ranges. Secures internal components in place. Order a new bracket if yours is bent, broken, or missing to restore proper fit.

Plastic endcap that covers and protects the side edge of your range control panel. Replace if cracked, broken, missing, or discolored to restore appearance.

Fix a range that won't respond to settings or displays error codes with this electronic control board. Restores oven temperature control and function.

Electronic control panel for ranges. Replaces broken, cracked, or malfunctioning touchpad interfaces. Restores oven timer and clock display functionality.

Deflector shield for gas range burners. Mounts around burner assembly to direct heat and protect components. Replace if cracked, warped, or missing.

The Knob is an OEM part for Frigidaire ranges and ovens. It allows the user to control the settings of the appliance, such as temperature and cooking modes, by turning the corresponding control valves or switches.

Over time, knobs can break, crack, or become stripped due to frequent use, making it difficult to adjust the settings accurately.

Symptoms of a bad knob include:

• Difficulty in turning or adjusting the knob
• The knob spinning freely without changing settings
• The knob becoming loose or falling off
• Inaccurate temperature or mode settings

This OEM replacement is also compatible with Electrolux, Gibson, Kelvinator, and Kenmore models.

This trim is a decorative finish piece for select ranges and wall ovens. It covers gaps and raw edges for a clean look and helps keep adjacent panels properly seated when the original becomes cracked, bent, or missing.

• Provides a finished appearance by covering exposed edges or gaps
• Helps maintain alignment of nearby panels or glass
• Replace if cracked, warped, missing, or no longer seats securely
• Common symptoms include loose/rattling panels and exposed or sharp edges

• Disconnect power; for gas models, also shut off the gas supply
• Wear gloves—edges can be sharp
• Remove old trim and transfer/reuse original screws or clips
• Align the new trim and secure with existing fasteners; confirm proper fit before reassembly

If your range control panel is unresponsive or the display won't light up, the control transformer may have failed. Supplies low-voltage power to controls.

This wiring harness is the OEM-style electrical connector assembly that routes power and signals between components for proper appliance operation. Replacing a damaged harness restores reliable electrical connections and function. What it does:

• Provides the bundled wires and connectors that link controls, motors and sensors
• Replaces frayed, burned or disconnected wiring that can cause intermittent operation or no power
• Restores secure, correct connections to help prevent arcing or short circuits
• Used when connectors are broken, pins are bent, or insulation is damaged

• Always disconnect power (unplug appliance or switch off breaker) before starting work
• Compare new harness to the old one and follow the appliance wiring diagram for routing and connections
• Use proper connector seating and secure harness with original clips or fasteners to avoid pinch points
• If you find melted connectors or significant damage, inspect associated components and replace as needed

Replacement #8 x 0.500 inch screw for securing panels, trim, and brackets in appliances. Needed when original fasteners are stripped, lost, or missing.