Parts for Kenmore 790.45003802 (79045003802, 790 45003802): Backguard Parts

Control console housing that covers and protects your range's touch pad buttons and display. Replace if cracked, broken, or worn to restore appearance.

Replace your range control board if the oven won't heat, display is blank, or buttons don't respond. Restores full electronic control functionality.

This replacement trim piece restores the finished look around the refrigerator door/console and covers worn or damaged edges for a clean, factory appearance. It helps keep the area looking new and hides cosmetic damage. What it does:

• Replaces worn, cracked or scratched decorative trim for a refreshed exterior finish
• Covers gaps and mounting edges to improve overall appearance
• Restores a uniform look around the door or control/console area after repair
• Helps protect underlying components from incidental contact and debris

• High-level replacement: remove any screws or fasteners securing the old trim before installing the new piece
• Align trim carefully with mounting features and snap or fasten per OEM orientation
• Use appropriate tools and protect adjacent finish to avoid scratches during installation
• Disconnect power if removing trim exposes electrical components; follow safety precautions

Heat-resistant gasket seals between cooktop and control panel components. Replace when cracked or damaged to contain heat and prevent spills. Verify fit.

Specs: 8 - 18 x 0.500

This replacement screw secures appliance panels, brackets, and internal components. It restores a tight, rattle-free fit and proper alignment when an original fastener is missing, stripped, or corroded.

• Fastens metal or plastic parts to the cabinet/frame
• Helps maintain alignment and reduce vibration or rattling
• Direct replacement for lost, damaged, or rusted hardware
• Keeps covers and brackets safely in place

• Disconnect power before servicing; for gas appliances, also shut off gas supply
• Match one-for-one with the original screw; verify length/type before installation
• Start threads by hand to avoid cross-threading; tighten snugly without overtightening
• Use the correct driver bit to prevent stripping the screw head