Parts for Maytag CGR3300XDW0: 02 - Backguard Parts

This backguard is the replacement rear console panel that restores the look and protective cover behind the range control area. It helps protect wiring and controls while keeping the appliance appearance neat and finished. What it does:

• Replaces a cracked, dented, rusted, or missing rear console panel
• Protects control wiring and components from spills and debris
• Restores a clean, factory appearance to the back of the range
• Helps prevent drafts behind the control area and keeps controls accessible

• Disconnect power to the appliance before starting any work.
• Range may need to be pulled away from the wall to access mounting screws.
• Use appropriate tools; some models require removing trim or control housing to install.
• Parts and edges may be sharp—wear gloves and handle carefully.

This factory screw secures appliance components to their mounting points. Replace missing, worn, or stripped hardware to restore a tight fit, proper alignment, and quieter operation across the affected assembly.

• Fastens panels, brackets, covers, or internal parts to the chassis or frame
• Helps maintain alignment and support, reducing rattle, vibration, or looseness
• Replaces missing or damaged screws that have backed out, broken, or stripped
• Restores secure mounting after service when original hardware is lost

• Disconnect power; shut off water or gas supplies before servicing
• Use the correct driver; start threads by hand to avoid cross-threading
• Match length and thread to the original location; do not substitute with longer hardware
• Tighten snugly; do not overtighten into plastic or thin metal

This factory fastener secures appliance panels, brackets, and internal components so everything stays aligned and quiet. Replacing a missing or damaged screw restores a tight fit and helps reduce vibration, rattles, and wear.

• Fastens metal or plastic parts to the cabinet/frame
• Maintains alignment of covers, ducts, housings, and brackets
• Replace if the head is stripped, threads are worn, or hardware is missing
• Symptoms can include loose or misaligned panels, rattling/vibration noises, or parts that won't stay secured

• Disconnect power and shut off gas/water before service.
• Match the screw to the original location and reuse existing holes/mounts.
• Start threads by hand to avoid cross-threading; tighten snugly without overtightening.
• Use the correct driver bit to prevent stripping the head.