Parts for Tappan TEF364AQF: 03 - Backguard Parts

Replace your range's backguard shield if the rear wall panel is cracked, dented, or damaged. Protects the wall behind your cooktop and covers wiring.

Replace a cracked or missing right-hand shield end cap on your range. This protective trim piece covers the end of the range shield for a complete finish.

Left-hand end cap shield for range oven doors. Replaces cracked, broken, or missing caps that protect the door edge. Installs on the left side of the door.

Signals when your range burners or oven are active. Replace when light fails to illuminate or stays on constantly. Confirm fit with your model number.

This left-side bisque end cap finishes and protects the refrigerator door edge, restoring a clean appearance and helping keep the door trim secure. It's a direct-fit replacement for worn, cracked, or broken end caps. What it does:

• Covers and protects the outer edge of the refrigerator door trim on the left side
• Restores a finished appearance when original trim is cracked, broken, or missing
• Helps keep door components and seals neatly aligned and supported
• Compatible with factory door trim to maintain proper fit and gap

• Read the appliance manual before beginning; unplug the appliance or turn off power to the unit when instructed by the manufacturer
• Remove any damaged trim carefully to avoid scratching the door finish
• Align the end cap with the door edge and snap or fasten per factory attachment points; use gentle pressure to avoid cracking
• If clips or screws are required, reuse original hardware or replace with OEM-specified fasteners

Mounting bracket that secures the clock assembly to your range control panel. Replace if the original is bent, broken, or missing during clock repairs.

Protects and diffuses your range's indicator light that signals when burners are on or surfaces are hot. Replace if cracked or missing. Easy install.

Burner stuck on high or won't heat? This surface element switch controls temperature for electric range burners. DIY repair in under 30 minutes.

Burner won't turn off or stuck on high? This surface element switch controls heat settings for large burners. Moderate DIY with panel removal.

This truss-head machine screw secures a switch to its mounting bracket or panel. Replacing a worn or missing screw restores a solid, aligned switch fit for reliable operation.

• Fastens the switch body to a bracket or chassis panel
• Helps keep the switch aligned for consistent actuation
• Replaces stripped, corroded, or missing mounting hardware
• Common symptoms: loose or wobbly switch, misalignment, rattling or vibration around the switch area

• Disconnect power to the appliance before servicing
• Start threads by hand to avoid cross-threading; tighten snugly without overtightening
• Verify thread size and length match the original hardware
• If multiple screws secure the switch, replace them in a consistent pattern to maintain alignment

Chrome screw secures handles, door trim, and internal components in ranges and ovens. Replace if lost during cleaning, stripped, or missing after moves.

Chrome screw secures handles, door trim, and internal components in ranges and ovens. Replace if lost during cleaning, stripped, or missing after moves.