Parts for DGGX2-96103A: Base Panel Parts

M4x8 hex washer head mounting screw for dryers. Replace broken, stripped, or missing screws that secure internal components and panels. Zinc-plated.

Dryer not heating or overheating? This auto reset thermostat cycles heat to maintain safe temperatures. Common fix for inconsistent drying.

This flame sensor detects the presence of a gas burner flame so the control knows when to allow gas flow, helping prevent unlit gas flow and ensuring safe ignition. It mounts at the burner for reliable flame sensing. What it does:

• Senses burner flame presence and signals the control to confirm ignition.
• Helps the range/oven shut off gas if the flame goes out unexpectedly.
• Common symptom: oven or cooktop igniter glows but appliance fails to stay lit.
• Common symptom: intermittent or no flame detection causing repeated ignition attempts.

• Disconnect electrical power and shut off gas supply before servicing.
• Handle the sensor carefully; avoid bending or contaminating the sensing tip.
• Install in the original mounting location and verify wiring connections match the removed part.
• After installation, follow the appliance ignition/test procedure in the service manual to confirm proper operation.

Fix a dryer that won't heat or ignite with this gas dryer ignitor replacement. Sparks the pilot flame in the combustion chamber. DIY-friendly repair.

Dryer won't start or stops mid-cycle? This main control module restores electronic control and cycle management in gas dryers. Moderate DIY repair.

The Dryer Leveling Leg is an OEM part for Fisher & Paykel dryers. It securely elevates and stabilizes the dryer unit on any floor surface. The leveling leg allows for balance, and level adjustment, and protects against moisture concerns.

Symptoms of an insufficient leveling leg include: 

• Dryer rocking or wobbling noticeably during operation
• Premature wear of internal tumbler bearings  
• Vents or doors failing to seal properly

Causes of a faulty leveling leg can be damaged from repositioning the heavy dryer on uneven flooring. Over time, repeated stress leads to fractures of mounting points. 

The Dryer Leveling Leg is an OEM part for Fisher & Paykel dryers. It securely elevates and stabilizes the dryer unit on any floor surface. The leveling leg allows for balance, and level adjustment, and protects against moisture concerns.

Symptoms of an insufficient leveling leg include: 

• Dryer rocking or wobbling noticeably during operation
• Premature wear of internal tumbler bearings  
• Vents or doors failing to seal properly

Causes of a faulty leveling leg can be damaged from repositioning the heavy dryer on uneven flooring. Over time, repeated stress leads to fractures of mounting points.