Parts for DGGX2-96103A: Top Deck And Electronics Parts

Stainless steel Phillips screw for securing dryer and washer panels, brackets, and trim. Replace stripped, missing, or corroded fasteners. Pack of 10.

If your dryer display is blank or unresponsive, this control panel assembly restores cycle selection and status visibility. Direct fit replacement.

Dryer not heating or overheating? This auto reset thermostat cycles heat to maintain safe temperatures. Common fix for inconsistent drying.

The Lid Assembly is an OEM part for Fisher & Paykel dryers. It consists of the dryer lid and attached hinges, which provide controlled access to the drying chamber.

Symptoms of a bad lid assembly include:

• Difficulty opening or closing the dryer lid
• Loose, unstable, or off-track movement of the lid
• Gaps in the lid seal letting heated air escape

Causes of failure can be stripped or worn-out hinges, broken seals or cracked plastic over prolonged use. Overloading the dryer can also put excess stress on the lid assembly.

This replacement lid use & care label provides the appliance's original on-lid instructions and safety reminders to help you operate and maintain your appliance correctly. Durable adhesive design keeps instructions visible where needed. What it does

• Replaces worn or missing on-lid instruction and care information
• Restores visible safety warnings and basic operating guidance
• Helps users follow recommended care to avoid damage or misuse
• Keeps important reminders in the location intended by the manufacturer

• Clean and dry the lid surface thoroughly before applying
• Peel backing and align label; press firmly from center outward to remove air bubbles
• Do not apply over wet or greasy surfaces; avoid repositioning after initial contact
• Dispose of old adhesive residue; follow appliance safety precautions when working around the lid