Parts for Thermador REF30QB(PRIOR-9708): Base With Toe Kick Panel (Rdds30vqb(Prior-9707)) (Rdds30vrs(Prior-9707)) (Red30vqb(Prior-9707)) (Red30vqrs(Prior-9708)) (Red30vqw(Prior-9708)) Parts

Flexible conduit cable that protects electrical wiring in your oven. Replaces cracked, damaged, or worn conduit. Installs between junction box and unit.

This snap bushing cushions and centers a rotating shaft or spacer, reducing wear and vibration for smooth appliance operation. Fits applications that require a 1.00 inch inside diameter and 1.468 inch outside diameter bushing. What it does:

• Provides a low-friction bearing surface to protect shafts and surrounding components from metal-on-metal wear
• Centers and stabilizes rotating parts to reduce vibration and noise
• Helps maintain proper clearance between moving parts for longer component life
• Used where a durable, press-fit snap bushing is needed for quick assembly

• One snap bushing

• Press into a clean, burr-free hole until the bushing snaps fully into place; do not force at an angle
• Verify correct orientation so the retaining lip seats against the mounting panel
• Replace any damaged or excessively worn bushings to prevent further component damage
• Disconnect power and follow appliance safety procedures before accessing internal components

Mounting bracket assembly for ranges and electric ranges. Secures components in place. Replace if bracket is bent, broken, cracked, or missing hardware.

Replacement catch spring for electric oven and range doors. This small metal spring secures the door latch mechanism. Order a new one if broken or missing.

This toe trim is a left-side replacement trim piece that restores the finished look of the appliance front and helps protect the cabinet edge. Durable white finish matches factory appearance for a clean install. What it does:

• Replaces a damaged, cracked, or missing left-side toe trim to restore the appliance's front appearance
• Covers and protects the lower cabinet/appliance edge from scuffs and debris
• Helps seal the gap between the appliance and floor for a neater look
• Matches factory color and fit to maintain original styling

• One left-side toe trim, white

• Intended for left-side installation; verify side orientation before installing
• Remove fasteners or clips from the old trim and snap or screw the new trim into place
• Use basic hand tools; avoid force to prevent damaging clips or surrounding panels
• Disconnect power if working near electrical components and follow all safety instructions

This right-side toe trim replaces a damaged or discolored lower front trim and restores the appliance's finished look while keeping the base protected from debris and scuffs. Made to match the original fit and appearance. What it does:

• Covers the lower front edge of the cabinet to improve appearance and prevent dirt from collecting under the unit
• Replaces cracked, warped or yellowed trim to restore a clean, finished look
• Helps maintain a consistent gap and alignment between the cabinet and the floor
• Compatible with units that use a right-side white toe trim

• One right-side white toe trim

• Basic snap-in or screw-in replacement; remove any clips or screws before prying trim free
• Use a plastic trim tool to avoid scratching surrounding surfaces
• Wear gloves to protect hands from sharp edges and power down/unplug appliance before working nearby

Secures oven door glass and keeps the inner panel aligned. Replace if your bracket is cracked, broken, or missing to restore proper glass support.

Aluminum pop rivet for cooktop assembly. Secures panels and components. Replace if missing, stripped, or damaged during disassembly or maintenance.