Parts for Kitchenaid 5KHBC412EOB0: 02 - Blender Parts

Replacement coupling arm for your blender. This connects the motor to the blade assembly. Order a new one if yours is cracked, broken, or worn down.

Blender won't blend or blades spin loosely? This arm shaft connects your motor to the blade assembly, restoring secure engagement and smooth blending.

Coupling arm for blenders that connects the motor to the blade assembly. Replace if cracked, worn, or stripped to restore proper blade rotation.

Coupling arm for blender base. Connects motor to blade assembly. Replace if cracked, stripped, or broken to restore proper blending function.

This genuine replacement screw secures appliance components for reliable fit and alignment during normal use. It replaces worn or missing fasteners to restore proper assembly and reduce rattling or loose panels. What it does:

• Fastens trim, panels or small assemblies to maintain structural fit
• Replaces stripped, corroded or missing screws that allow parts to shift
• Helps stop vibration noise caused by loose components
• Matches OEM fit so connected parts align correctly

• Use the correct driver size to avoid stripping the head
• Tighten until snug; do not overtighten to prevent thread or part damage
• Disconnect power to the appliance before servicing any electrical areas

Replacement push button for blender control panel. Restores tactile interface when original button is cracked, worn, stuck, or missing. Snap-in design.

This trim band is the exterior door trim piece that restores the appliance's finished appearance and helps secure the door edge. It replaces cracked, dented, or missing trim to improve fit and reduce rattling or gaps. What it does:

• Replaces damaged or worn door trim to restore a clean, finished look
• Helps hold the door edge and adjacent panels in place for proper alignment
• Can reduce rattling or drafts caused by loose or broken trim
• Prevents further chipping or damage to the door edge by covering exposed areas

• Disconnect power to the appliance before starting any repair
• Remove the door or access panel per the manufacturer instructions to reach trim
• Use common hand tools; avoid over-tightening fasteners to prevent cracking the trim
• Handle edges and any attached glass carefully

If your blender won't turn on or powers off unexpectedly, a faulty power switch is often the cause. This replacement switch restores control functionality.

This adaptor connects compatible plumbing or hose fittings to restore a secure, leak-resistant connection on select Whirlpool appliances. It provides a reliable join between mating components so the appliance can move water as intended. What it does:

• Joins two hose or plumbing fittings to create a sealed connection
• Helps prevent leaks at a coupling or transition point
• Restores proper water flow where a damaged or missing adaptor caused leakage or poor drainage
• Useful when replacing worn, cracked or corroded connector pieces

• Disconnect power and shut off water supply before servicing
• Inspect mating surfaces and replace any damaged clamps, gaskets or hoses
• Threaded fittings may benefit from plumber's tape; tighten by hand first, then snug with tools
• Replace the adaptor rather than reusing a cracked or deformed piece

Replace your blender's blade assembly if it's dull, bent, or damaged. This blade installs at the base of the blender jar and is essential for blending.