Parts for Electrolux E30WD75ESS2: 03 - Body Parts

8-18 x 0.500 mounting screw for appliances. Secures panels, brackets, and components. Replace if stripped, missing, or damaged during repairs.

Burner won't turn off or element light stays on? This range burner control switch regulates temperature and power. Moderate DIY repair, 30-60 minutes.

Secures burner switch to mounting bracket for reliable control. Prevents switch misalignment causing stuck or unresponsive burners. Easy 10-minute fix.

Range won't heat or overheats? This safety thermostat protects against excessive temperatures. Direct replacement part for reliable operation.

Hold down clip secures your warming drawer to the range body. Replace if drawer sags or doesn't stay in position. Verify fit with your model number.

This replacement cover restores the appliance's outer housing to protect internal components and maintain a finished appearance. It fits where the original cover was mounted and keeps debris and moisture away from sensitive parts. What it does

• Shields controls and internal components from dust, spills and everyday wear
• Restores a secure, finished look to the appliance exterior
• Helps prevent exposed wiring or parts that can cause shorting or malfunction
• Common symptom: cracked, broken or missing cover that leaves components exposed

• One replacement cover

• Disconnect power before beginning any service
• Remove retaining screws or clips holding the old cover and keep fasteners for reinstallation only if they are in good condition
• Align tabs or screw holes and secure the new cover without over-tightening

This snap bushing is a push-in panel grommet that protects and secures wiring where harnesses pass through metal or plastic panels. It prevents chafing and helps keep wire routing neat for safer operation. What it does:

• Cushions and shields wires from sharp panel edges to reduce abrasion and shorts
• Secures wiring harnesses in place to prevent unwanted movement or snagging
• Provides a finished, vibration-resistant pass-through for electrical leads
• Commonly replaced when the original bushing is cracked, broken, or missing

• One snap bushing

• Disconnect power before servicing electrical components
• Press-fit into the panel hole until the bushing snaps into place; confirm a secure fit
• Replace if brittle, torn, or deformed; do not use a damaged bushing
• Use pliers for removal if needed; avoid forcing or enlarging the hole

Specs: 10-32 X 0.375

Replacement #8 x 0.500 inch screw for securing panels, trim, and brackets in appliances. Needed when original fasteners are stripped, lost, or missing.