Parts for Ge ZET1038BF3BB: 02 - Upper Oven Parts

This halogen light bulb restores bright, reliable illumination inside your appliance, making it easier to check food and read controls. Replace a burned-out or broken lamp to bring back safe, convenient visibility while cooking.

• Provides bright lighting for the appliance cavity or work area
• Direct replacement for a failed, flickering, or shattered bulb
• Helps you monitor cooking progress without opening the door
• Typical symptoms: light won't turn on, intermittent flicker, blackened or broken glass

• Disconnect power by unplugging the unit or switching off the circuit breaker before servicing
• Allow the light area and lens to cool completely
• Handle halogen bulbs with a clean cloth or gloves; avoid touching the glass
• Install per your appliance's instructions and ensure the bulb is fully seated and any cover is secured

This is a replacement trim piece that fits around the oven bake element to restore a finished appearance and help secure the element assembly. It replaces a damaged, bent or missing trim so the element mounts cleanly and safely. What it does

• Provides a finished trim around the bake element opening to restore oven appearance
• Helps hold the bake element in its proper position and alignment
• Covers gaps or sharp metal edges left by a damaged or missing trim
• Common symptom: visible damage, missing trim, rough or sharp edges around the element area

• One replacement bake element trim

• Disconnect power to the range before any service to avoid electrical shock
• Access typically requires lowering or removing the oven door and pulling the oven cavity forward; keep track of fasteners
• Handle metal trim carefully to avoid cuts; use gloves as needed
• If the bake element is loose or damaged, inspect the element and mounting hardware and replace separately if required

This ring-style convection heating element mounts around the fan at the back of the oven and supplies heat for convection cooking. Replacing a failed element helps bring back even air heating and consistent convection bake performance.

• Provides the heat source for convection bake/roast by warming air circulated by the fan
• Helps maintain set temperature and more even results in convection mode
• Common failure signs: no heat in convection while the fan runs, slow or incomplete preheating, uneven baking, visible breaks/blisters, or an open circuit on a continuity test
• Designed to cycle under control of the oven's sensor and electronic controls

• Disconnect power at the breaker or unplug the appliance before servicing
• Access may be from the rear of the appliance or by removing the interior panel over the convection fan, depending on the model
• Label and support the two element leads to keep them from retracting into the cavity; ensure terminals are fully seated
• Reuse existing mounting hardware; avoid bending the new element and verify it doesn't contact the oven cavity

Cooling fan assembly circulates air to remove heat from the appliance's condenser and electronics. Replacing a failing cooling fan restores airflow, helps prevent overheating, and improves overall cooling performance. What it does:

• Moves air across condenser/compressor and internal components to dissipate heat and support proper cooling.
• If the motor or blade fails, common symptoms include no airflow or intermittent operation.
• Worn bearings, debris, or damage can cause loud grinding, rattling, or unusual noise during operation.
• A working cooling fan helps the appliance run on normal cycles and reduces excessive run time caused by poor heat removal.

• Disconnect power before starting — always unplug or switch off the breaker to avoid electric shock.
• Handle sheet metal edges and components carefully; wear gloves to prevent cuts.
• Note connector orientation, wiring, and mounting screw locations during removal for correct reinstallation.
• After install, restore power and verify fan runs quietly and provides steady airflow.