Reed H Beaver Falls , PA January 03, 2016 Recently had granet countertops installed dishwasher was slidimng around needed to install side mounts to corral the dish washer Easily installed the side mounts and put new trim around the opening. Read More... 20 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Screwdrivers
Peter B Chester , MD October 25, 2014 Appliance: Model BOSCH The undercounter bracket broke and dishwasher tipped forward when racks pulled out These brackets fit perfect for my Bosch and Were really easy to install Read More... 7 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers
Robert W Ridgefield , CT November 20, 2015 Unsecured dishwasher Ordered side mount Bosch brackets from Appliance Parts, that was the easy part. Had to retract the legs, disconnect the (short) water supply line, then remove the door gaskets to get the unit out of the cabinet area to install the side mount brackets. Repair took over 90 minutes unlike the quick video demonstrated. Read More... 4 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 1-2 hours Tools: Adjustable Wrench, Pliers, Screwdrivers, Wrench Set
Bernard C Macomb , MI July 04, 2015 Appliance: Model LGR66112Q0 Ignitor would light but no flame Checked igniter with an ohmmeter and found it to be functioning. Did the same with the gas valve coils according to the Appliance Pros web site and they too appeared to be functioning. Based upon the repair video, the ohms test could be inconclusive. I tested the remaining parts and they seemed to be functioning. The most likely source of the problem appeared to be the coils. I replaced them and the twenty some year old dryer works fine. Read More... Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Screwdrivers, Socket Set
Gregory E Woodhaven , MI January 24, 2022 Appliance: Bosch Dishwasher SHE46C06UC/22 No circulation motor operation. Replaced control unit to fix. The initial problem included no water fill. So also replaced the water inlet valve/solenoid and float control switch. No circuit diagram. Deduced problem by checking voltage (or lack thereof) at circulation motor. Controller retention in the faceplate was clever and tricky to remove. Pulled dishwasher from cabinet to check voltage at the motor. Read More... Do-It-Yourself Rating: Repair Time Estimate: 1-2 hours Tools: Adjustable Wrench, Nut Drivers, Screwdrivers