Lawrence P Merrimac , MA December 10, 2021 Rubber sound insulation deteriorated on Bosch custom paneled door model After custom panel was removed replacement was obvious and simple. Took a while to find the custom panel instructions on the Bosch site to see which screws needed to be removed. This was in a separate document from the regular installation instructions. Made a pencil line on the metal as a guide and cleaned off old adhesive just to ensure new one stuck on OK. Read More... 12 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Screwdrivers
Gordon F Santa Barbara , CA March 22, 2026 Appliance: Bosch Dishwasher SHXM78Z55N/01 Sound insulator flap had deteriorated falling apart Replacement entailed disassembly of the door (12 Torx screws) but did not require pulling the dishwasher out. Excellent video for this repair: https://youtu.be/GBFJc4ZSKiE?si=7lliBGXAdBvRqwnZ Read More... 6 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Screwdrivers
Jerry M Spotsylvania , VA November 02, 2025 Appliance: Model SHPM88275N/01 Bosch dishwasher rubber sound guard deteriorated Replaced the rubber piece. Unlike many DYI who removed virtually the entire inside door, I positioned the new sound guard (in the reverse position) on the front door, set it so when I folded the bottom piece (with adhesive strip) up, it would align perfectly. Then I taped it to the door giving me the freedom to slowly adhere the piece to the inside door frame. Read More... 3 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Screwdrivers
Arthur K Flushing , NY May 26, 2026 Appliance: Bosch Dishwasher SHP878ZD5N/01 The sound insulation wore out and was hanging down I reached up under the door and peeled off the old material that was hanging down. I then removed the toe kick and took out the remaining material. I then reached up under the door and cleaned the surface with some alcohol and then carefully held the new piece in place. when I was happy with its location, I had my boss (D Wife) attach tape to the section hanging down. Once the tape was in place, I removed the glue strip cover from the part and pressed it into place inside the door, the tape allowed me to pull the new part to exactly where I wanted it. I then draped it down and put the toe kick cover back in place. Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Screwdrivers
Karl S Clarksville , MD August 15, 2022 The worn out rubber insulator Bought a new Sound Insulator, fit right in. Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Screwdrivers