Bosch Washer Valve

The Cold Water Inlet Valve is an OEM part for Bosch washing machines. It is designed to regulate the flow of cold water into the washing machine during the wash cycle. This valve operates based on signals from the washing machine's control board, ensuring the right amount of cold water is provided.

Causes of a faulty cold water inlet valve can include wear and tear over time, clogs or blockages in the valve, electrical issues, or valve failure.

Symptoms of a bad cold water inlet valve may include:

• Insufficient or no cold water flow into the washing machine
• Leaking or dripping water from the valve during the wash cycle
• Inconsistent or inadequate water supply for washing clothes
• Error codes related to water supply or filling

This OEM Bosch part is also compatible with Thermador, Gaggenau, and some Kenmore models.

Note: For the Hot Water Valve, order part number 00422245.

The Hot Water Inlet Valve is an OEM part for Bosch washing machines. It regulates the entry of hot water into the machine, crucial for cycles requiring warm or hot washes. Activated by the machine's control system, this valve opens at the precise moment to allow the correct amount of hot water to mix with the cold, ensuring the selected temperature setting is accurately achieved. 

The causes behind issues with the hot water inlet valve often include sediment build-up from hard water, wear and tear from regular use, or electrical failures preventing the valve from operating.  

Symptoms of a malfunctioning Hot Water Inlet Valve include:

• Water that is too cold 
• No water entering the machine 
• Leaks around the valve area 

This genuine OEM Bosch part is also compatible with Thermador, Gaggenau and select Kenmore models.

This valve magnet is the solenoid actuator used to open and close a dishwasher water/control valve, restoring proper water flow for filling and cycle operation. It replaces a failed or weak magnet to help the valve respond correctly. What it does:

• Converts electrical signal into linear motion to operate the dishwasher valve
• Restores valve opening and closing when a worn or stuck magnet causes fill or circulation issues
• Commonly used when dishwasher won't fill, stops mid-cycle, or shows related valve/fill errors
• Works with the valve body; does not include seals or the full valve assembly

• Disconnect power and shut off the water supply before beginning service
• Replace with the matching OEM magnet and ensure proper seating on the valve body
• Keep terminals dry and secure electrical connections; inspect gaskets and valve body for damage

Fix a washer that won't stop filling or overflows during cycles. This water valve magnet controls water flow during wash and rinse. Common DIY repair.

Fix water leaking into your washer when off or during cycles. This dual inlet valve controls hot and cold water flow. Accessible from the top panel.