Parts for Huebsch 30WG: Burner Assembly Parts

Dryer won't start or shuts off too soon? This high limit thermostat prevents overheating by cutting power when temps get too high. Easy 20-min fix.

This sensor monitors operating conditions and relays accurate feedback to the control so cycles run properly. Replacing a failed sensor helps restore correct operation and prevent erratic behavior or fault codes. What it does:

• Detects a specific operating condition and sends a signal to the control
• Helps the machine regulate cycle timing and performance
• Can cause error codes, cycles that won't start or advance, or intermittent shutdowns when failing
• Lead to inconsistent temperatures or sensing behavior depending on application

• 1 sensor

• Disconnect power (and shut off gas/water, if applicable) before servicing
• Access the sensor; note wire positions and connector orientation
• Install the new sensor in the same location and orientation; seat connectors fully
• Clear any stored faults and run a test cycle per the tech sheet

This replacement igniter is the glow-style heating element that lights the gas burner in compatible gas dryers, restoring reliable ignition so the dryer can produce heat when calling for a cycle. What it does

• Heats to a glowing temperature to ignite burner gas when the dryer starts
• Replaces a cracked, broken, or non-glowing igniter that prevents the burner from lighting
• Common symptom: dryer runs but does not produce heat
• Also used when the igniter shows visible damage or fails continuity checks

• One igniter (glow bar)

• Disconnect electrical power and shut off gas supply before servicing
• Handle the ceramic/element carefully; the glow element is fragile and can break if touched or dropped
• Follow OEM service instructions and replace any suspect mounting hardware or sensors encountered during replacement

Spring and connector assembly for dryers. Replaces worn, broken, or missing components. Essential hardware for proper dryer operation and assembly.

Fix weak flames or improper heating in your gas dryer with this burner orifice. Controls gas flow to the burner assembly. Quick DIY repair in under an hour.

This manifold pipe assembly routes gas from the valve to the burner assembly to enable safe, even heating. It's a direct-fit replacement that restores proper gas flow and reliable burner operation. What it does

• Distributes gas from the main gas valve to the dryer/burner ports for ignition
• Helps maintain consistent burner operation and even heating
• Faulty manifold can cause no heat, intermittent heating, or a persistent gas smell
• Works with the appliance's burner and valve components to ensure correct gas delivery

• One manifold pipe assembly

• Turn off gas supply and electrical power before servicing
• Inspect and replace any related gaskets, seals, or mounting hardware as needed
• Use correct OEM fasteners and tighten to manufacturer guidance; avoid forcing or bending the pipe
• If you smell gas after installation, turn off gas immediately.

Fix a dryer that won't heat or produces weak heat with this burner assembly. Common solution for gas dryers with heating issues. Moderate difficulty repair.