Parts for Electrolux EFDC210TIW01: Burner Parts

This replacement pump assembly moves and removes water to restore normal appliance drainage and reduce standing water or leaks. It's a direct-fit service part designed to bring back proper water flow and quiet operation. What it does:

• Pumps water out of the appliance to enable normal draining and cycle completion
• Can resolve symptoms like standing water, incomplete cycles, or intermittent draining
• Helps address related drain or pump fault indications reported by the appliance

• Always disconnect power to the appliance before starting any repair
• Turn off water supply and drain residual water where applicable to avoid spills
• Remove access panels and mount hardware; note wire and hose locations before disconnecting
• After installation, restore power/water, run a short cycle, and inspect for leaks and proper operation

This dual radiant surface heating element restores reliable burner performance on electric glass-ceramic cooktops and ranges. It delivers selectable 240V output—use the 700W inner ring or the 1900W outer ring—to match pan size and heat efficiently.

• Heats the selected surface burner zone when the control is turned on
• Two heating areas (inner/outer) let you choose power for small or large cookware
• Common symptoms of a failed element: burner won't heat, only one ring heats, uneven heating, or visible hot spots/damage on the element
• Rated 240V; 1900W (outer) + 700W (inner)

• Disconnect power at the breaker before servicing
• Lift/remove the cooktop to access the element; support the glass to prevent stress or cracks
• Note wire locations and transfer one at a time to the new element
• Reuse existing brackets/clips; do not overtighten fasteners against the ceramic base

Dryer won't start or respond to controls? This control switch assembly restores on/off functions and user input response. Direct-fit replacement.

Dryer not heating properly or overheating? This temperature sensor monitors and regulates heat levels. Direct replacement restores safe, efficient drying.

If your dryer overheats or won't heat properly, the temperature probe may have failed. This sensor monitors internal temperature for accurate heating.