Parts for Frigidaire TGC8X3XCC3: 03 - Burner Parts

By Frigidaire. 2+0 module type. Employs two spark electrodes for manual surface ignition of a four burner range top with flash tubes to front and rear burners. Very popular module used on many different brands and models. Check by appliance model number, if not sure.

This pressure regulator controls gas flow to the range valve, helping maintain steady burner operation for safe, consistent flames. It replaces a worn or failed regulator to restore proper gas delivery and reliable ignition performance. What it does:

• Regulates incoming gas pressure to the range's control valve for steady burner flames
• Helps correct issues like weak or uneven flames and burners that struggle to light
• Reduces risk of high-pressure surges that can affect burner performance
• Works as a direct replacement when the existing regulator is faulty or leaking

• Turn off the gas supply and power before starting any work; always follow appliance shutoff procedures
• Inspect fittings and seals; use proper thread sealant for gas-rated connections if required by the manufacturer
• After installation, perform a gas leak check and verify correct burner operation and flame appearance

This is a replacement screw used to secure appliance panels and components. It restores proper fastening so panels, trim, or assemblies stay tight and reduce vibration or rattling. What it does

• Fastens panels, brackets, or trim to the appliance chassis
• Helps stop loose or vibrating panels and trim pieces
• Restores proper alignment where a missing or stripped screw causes gaps or movement
• Use when the original screw is missing, damaged, or corroded

• One replacement screw as shown

• Disconnect power to the appliance before starting any repair
• Use the correct screwdriver or bit to avoid stripping the screw head
• Tighten until snug; avoid over-torquing which can strip threads or crack plastic
• Keep removed screws in a safe place; this screw matches the original before installation

This retainer bracket secures a small appliance component or assembly in place to keep parts aligned and reduce movement. It helps restore proper fit and stops noise or shifting caused by a loose or damaged bracket. What it does:

• Holds and positions a component or panel to maintain alignment and function
• Prevents rubbing, rattling, and vibration from loose assemblies
• Restores proper clearance where a failed bracket caused gaps or misalignment
• Used when a corroded, bent, or broken bracket no longer secures parts safely

• Disconnect power and, for refrigerators/freezers, turn off the water supply before servicing.
• Remove necessary panels or shelves to access the bracket; keep fasteners organized.
• Replace the bracket using the same mounting holes and hardware; do not force fit.
• If sharp edges are present, wear gloves and test the appliance operation after reassembly.