Parts for Whirlpool GC900QPPB2: 03 - Cabinet And Control Parts

Color: Black

Color: White

Replacement fastener screw for appliances. Secures panels, trim, clips, and components. Needed when original screws are stripped, missing, or damaged.

This power cord plate covers and secures the oven/range power cord where it enters the appliance, keeping the connection protected and helping prevent strain on the cord. It restores a finished look and helps keep wiring safely routed. What it does:

• Covers the terminal block area to protect power connections from dirt and accidental contact
• Helps keep the power cord routed and secured to reduce strain on the cord and terminals
• Can prevent air/dust intrusion behind the control cavity that could affect components
• Common replacement when the original plate is cracked, broken, or missing

• Always disconnect power at the breaker or unplug the appliance before starting work
• Typically attaches with two screws; keep screws and any gaskets from the old piece for reuse if undamaged
• Check the cord strain relief/terminal connections while replacing the plate; do not touch live terminals
• If wiring or the cord itself is damaged, replace or repair those parts per manufacturer instructions

Fix a trash compactor that won't turn on or off with this control switch. Direct replacement part installs in minutes with basic tools.

Lost your trash compactor's red on/off switch knob? This key-style control knob restores operation in minutes. Simple plug-in installation—no tools needed.

White switch plate for trash compactors. Covers and protects the control switch area. Replace if cracked, discolored, broken, or missing.

Black mounting plate that secures the switch assembly in your trash compactor. Replace if cracked, broken, or missing to properly support switch components.

Color: Black

Color: White

Fix a refrigerator light that won't turn on or off when you open the door. This push-button switch senses door position. DIY repair in 30 minutes.

Fix a compactor that won't start, stops mid-cycle, or requires holding the pedal down. This drawer tilt switch is a quick 15-second replacement.

Fix a compactor that won't stop running at the top of the cycle with this off switch. Simple DIY repair restores proper shutoff and cycle control.

Sheet metal pan head screw secures panels, brackets, and components to appliance cabinets. Replace missing, stripped, or corroded screws to restore fit.

Color: White

Cracked or damaged control panel trim? This escutcheon covers and protects control switches from grease and spills. Simple install, reuse screws.

Size: 8-32 x 1/4 inch.

Fix a worn or cracked start button area on your trash compactor with this peel-and-stick control panel insert. Easy 5-minute DIY repair restores appearance.

Decorative insert that fits into the recess on your trash compactor panel to finish the assembly. Replace if cracked, peeling, worn, or missing.

This protective component secures the power cord where it enters the washer cabinet, preventing wire damage from movement or strain. Replace if the power cord pulls loose, shows signs of damage at the entry point, or the washer intermittently loses power.

Secures the rotary control switch to your trash compactor's front panel. Replace if stripped, missing, or loose to keep the control knob stable and aligned.

This replacement screw secures panels, brackets, and internal components inside your appliance to keep them aligned and rattle-free. Replace stripped, rusty, or missing hardware to restore a tight fit and dependable operation.

• Holds metal panels, brackets, ducts, or trim in place
• Helps maintain alignment and reduces vibration and noise
• Replaces missing, corroded, or stripped screws
• Common symptoms: loose panel or component, rattling/buzzing during use, screw won't tighten

• Disconnect power and shut off gas/water before servicing
• Start threads by hand to avoid cross-threading; use the correct driver
• Replace one fastener at a time to maintain alignment
• Tighten snugly—do not overtighten to prevent stripping

Replace a missing or broken control panel button plug on your trash compactor. This small cap covers unused button openings for a finished look.