Parts for Bosch WFL2060UC/01: Cabinet Parts

The Affresh Washer Cleaner 3 Pack is an OEM cleaning accessory designed specifically for washing machines. This multipack contains 3 packets of a proven formula that helps eliminate odors from the washer tub, door, gasket, and drain areas. Regular cleaning is important to remove dirt, soap scum, mildew, and other residue that can build up over time and lead to odors. The Affresh tablets contain oxygen-powered enzymes and fresh scent boosters that are released during the cleaning cycle to safely and effectively eliminate musty smells.

This multipack of Green 4.2-ounce tablets ensures you have enough doses for consistent cleaning to keep your washer smelling fresh. As the #1 recommended washer cleaner brand, Affresh is also compatible for use in Maytag, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and select Kenmore washers.

Top. 1 included. Front load

Side. 1 included. Front load

This small plastic push-on cap covers and protects exposed shafts or fasteners to restore a finished appearance and prevent debris buildup. Fits specific Bosch appliance locations where a cosmetic protective cover is required. What it does:

• Covers exposed shafts, posts, or screw heads to prevent dirt and snagging
• Restores the appliance's finished look after part replacement or repair
• Helps keep moisture and debris out of small openings around mounting points
• Simple, non-mechanical part—no electrical or moving components

• Push the cap onto the matching shaft, post, or fastener until it seats firmly
• Use gentle pressure to avoid deforming the cap; do not force onto mismatched sizes
• Disconnect power to the appliance before accessing internal panels or fastener areas
• Replace only with the correct cap size for the specific location to ensure a secure fit

This replacement foot supports and levels your appliance so it sits steady and operates smoothly. Replace a worn or missing foot to restore proper height, reduce wobble, and help protect surrounding surfaces.

• Supports the base/frame to maintain proper height and alignment
• Provides leveling adjustment so the unit remains stable
• Helps reduce rocking, vibration, and rattling during operation
• Replace if the original foot is cracked, stripped, missing, or won't adjust

• Disconnect power; shut off water or gas supplies if applicable
• Carefully tilt or raise the unit to access the foot location
• Remove the damaged foot and install the new one per design
• Level the appliance front-to-back and side-to-side; verify stability before use

A front lower trim piece that finishes the base of the washer and helps protect the cabinet opening from debris. Replaces a cracked, dented or missing toe kick to restore a clean appearance and proper fit at the washer's base. What it does

• Covers and protects the washer's lower front opening from dust and small debris.
• Restores the factory appearance when the original toe kick is damaged or missing.
• Helps reduce visible gaps that can catch lint or small items.
• Stops rattling or loose fit at the base when the original piece is bent or broken.

• One front lower toe kick panel (single piece as shown)

• Disconnect power and water before doing any service that requires removing panels.
• Access typically requires removal of the lower access panel or front service panel—keep small fasteners in a secure place.
• Handle edges carefully to avoid cuts; use gloves if needed.

A front lower trim piece that finishes the base of the washer and helps protect the cabinet opening from debris. Replaces a cracked, dented or missing toe kick to restore a clean appearance and proper fit at the washer's base. What it does

• Covers and protects the washer's lower front opening from dust and small debris.
• Restores the factory appearance when the original toe kick is damaged or missing.
• Helps reduce visible gaps that can catch lint or small items.
• Stops rattling or loose fit at the base when the original piece is bent or broken.

• One front lower toe kick panel (single piece as shown)

• Disconnect power and water before doing any service that requires removing panels.
• Access typically requires removal of the lower access panel or front service panel—keep small fasteners in a secure place.
• Handle edges carefully to avoid cuts; use gloves if needed.

The Affresh Washer Cleaner 3 Pack is an OEM cleaning accessory designed specifically for washing machines. This multipack contains 3 packets of a proven formula that helps eliminate odors from the washer tub, door, gasket, and drain areas. Regular cleaning is important to remove dirt, soap scum, mildew, and other residue that can build up over time and lead to odors. The Affresh tablets contain oxygen-powered enzymes and fresh scent boosters that are released during the cleaning cycle to safely and effectively eliminate musty smells.

This multipack of Green 4.2-ounce tablets ensures you have enough doses for consistent cleaning to keep your washer smelling fresh. As the #1 recommended washer cleaner brand, Affresh is also compatible for use in Maytag, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and select Kenmore washers.

This door hinge bushing sits between the hinge and pivot point to reduce friction and wear. Replacing a worn bushing restores smooth, quiet door movement and helps keep the door properly aligned over time. What it does:

• Provides a smooth, low-friction pivot surface for the hinge
• Helps maintain door alignment and consistent opening/closing feel
• Reduces squeaks, grinding, or binding from the hinge area
• Replaces cracked, flattened, or missing bushing that can make the door feel loose or stiff

• 1 door hinge bushing

• Disconnect power to the appliance before servicing
• Support the door to relieve hinge tension; hinges may be spring-loaded—control door movement
• Access the hinge per your model's service information and note the bushing's orientation
• Install the new bushing, reassemble, and test door travel and latching

Restore smooth, secure door movement with this door hinge. It supports and guides the door through opening and closing, helping ensure proper alignment and consistent sealing so the appliance operates safely and efficiently.

• Supports the door's weight and pivots for smooth opening/closing
• Helps maintain correct door alignment and gasket contact
• Wear or damage can cause sagging, misalignment, noisy operation, or incomplete closing
• Replacing a worn hinge can improve door seal and overall performance

• Disconnect power and allow the appliance to cool before service
• Support the door during removal to prevent strain on the remaining hinge
• Transfer any original fasteners to the new hinge if re-used
• Check door alignment and operation before restoring power

The Fastening Ring is an OEM part for Bosch front load washers. It secures the door boot seal to the front panel of the washer, ensuring a tight and leak-free connection. This ring is essential for maintaining the washer's seal during operation, preventing water from escaping the drum.

Causes of a bad fastening ring can include normal wear and tear, rust or corrosion, and damage from over-tightening or mishandling during maintenance.

Symptoms of a bad fastening ring include:

• Water leaking from the door area
• The door boot seal becoming loose or detached
• Visible damage or deformation of the ring

This OEM Bosch part is also compatible with Thermador, Gaggenau, and some Kenmore models.

This gray rear door panel forms the inner half of the washer door assembly. Replacing a cracked or warped panel restores door integrity, supports the glass, and helps the door seal close and latch as designed. What it does:

• Serves as the inner structure of the washer door and mates with the outer frame
• Supports and positions the door glass and related trim
• Helps maintain proper seal between the door and tub boot to minimize leaks
• Common symptoms: cracked/broken panel, difficulty latching, door misalignment, leaks at door area

• 1 rear door panel in gray

• Disconnect power and turn off water supply before servicing
• Remove the door from the hinge, then separate the door halves by removing perimeter screws/clips
• Transfer the door glass and any reusable hardware/trim to the new panel; keep orientation consistent
• Inspect the door boot lip and ensure it seats properly; verify smooth closing and latching before use

This front door panel replaces the outer frame of the washer door, restoring appearance and proper alignment. It frames the window and interfaces with the handle/latch components so the door closes and latches as designed.

• Forms the exterior frame around the door glass and completes the door assembly
• Provides alignment for door components to help ensure smooth closing and latching
• Replaces cracked, broken, or discolored outer door trim/panel
• Can help resolve issues like loose-feeling doors or doors not aligning with the latch

• Disconnect power before servicing
• Open the door, support the assembly, and remove the perimeter screws securing the outer panel
• Transfer any components attached to the old panel, position the new panel, and tighten screws evenly
• Check door alignment and latch operation before returning the appliance to service

The Handle Washer is an OEM part for Bosch front-loading washing machines. It provides an ergonomic grip to facilitate opening and closing the washer door. 

Causes of a bad handle washer can include cracks, chips, or breaks due to impact or regular use over time. Harsh chemicals or prolonged sun exposure can also degrade the material.

Symptoms of a bad handle washer include: 

• Difficulty gripping the handle securely  
• Sharp or rough edges pose a safety hazard
• Loose attachment making the handle unstable
• Discoloration or deterioration impacting aesthetics

This genuine OEM Bosch part is also compatible with Thermador, Gaggenau and select Kenmore models.

Door handle pin secures the appliance door handle to the door assembly, restoring a firm, stable grip and preventing the handle from slipping or detaching. What it does:

• Acts as the pivot/fastening pin that holds the door handle to the door or door trim.
• Replaces worn, bent, or broken pins that cause loose, wobbly, or sagging handles.
• Helps prevent the handle from falling off or catching when opening and closing the door.
• Restores proper alignment and reliable leverage for normal door operation.

• Disconnect power to the appliance before starting any work; for water-connected appliances also turn off water supply.
• Remove the handle and any trim carefully to access the pin; keep small fasteners in a safe place.
• Install the pin in the same orientation as the original; if retaining clips or bushings were present, reuse or replace them as needed.
• If you encounter springs, clips, or hidden fasteners, proceed cautiously.

This latch secures the appliance door closed and lets the control know when it's safe to run a cycle. Replacing a worn or damaged latch restores reliable door closure and consistent cycle starts.

• Engages the door strike to hold the door shut during operation
• May include an internal switch that signals door-closed status to the control
• Helps prevent cycle interruptions caused by a door-ajar condition
• Common symptoms: door won't latch, door pops open, cycle won't start, "door open" message or beeping

• Disconnect electrical power before servicing; shut off water supply if applicable
• Access and fasteners vary by model; latch mounts at the door/front panel area
• Transfer any mounting hardware and connectors from the original part one-for-one
• After installation, verify proper alignment with the door strike and that the unit recognizes "door closed"

2 included - Front load

The Affresh Washer Cleaner 3 Pack is an OEM cleaning accessory designed specifically for washing machines. This multipack contains 3 packets of a proven formula that helps eliminate odors from the washer tub, door, gasket, and drain areas. Regular cleaning is important to remove dirt, soap scum, mildew, and other residue that can build up over time and lead to odors. The Affresh tablets contain oxygen-powered enzymes and fresh scent boosters that are released during the cleaning cycle to safely and effectively eliminate musty smells.

This multipack of Green 4.2-ounce tablets ensures you have enough doses for consistent cleaning to keep your washer smelling fresh. As the #1 recommended washer cleaner brand, Affresh is also compatible for use in Maytag, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and select Kenmore washers.