Parts for Frigidaire FPCE22VWFA3: 04 - Cabinet Parts

Replacement mounting screw for securing brackets, trims, covers, and components inside your refrigerator. Replace missing, stripped, or lost hardware.

This thin shim adjusts the alignment and spacing of your freezer door hinge. It ensures the door closes properly and maintains an airtight seal for efficient operation. Install this shim if your freezer door doesn't close completely, has gaps around the seal, or if the door appears misaligned.

This part has been discontinued by the manufacturer and is no longer available.

Upper door hinge for refrigerators. Mounts at the top of the door to secure it to the cabinet. Replace if cracked, broken, or worn causing door misalignment.

Factory fastener that secures panels, brackets, and internal components. Replace missing, stripped, or corroded screws to restore tight fit and eliminate rattling.

Refrigerator bottom hinge shim that provides proper spacing and alignment for your door hinge. Replace if worn, damaged, or missing to restore fit.

Interior light not turning on when you open the door? This door-actuated switch restores automatic lighting control. Simple snap-in repair in minutes.

Replace a loose or missing extension lock washer causing rattling noises or unstable component mounting. Simple DIY fix in under 15 minutes.

Freezer drain tube that channels defrost water from the drain pan to the drip pan. Replace if cracked, leaking around the grommet, or causing floor leaks.

This part has been discontinued by the manufacturer and is no longer available.

A small replacement pin used to secure and align moving parts in the appliance for reliable operation and correct fit. Replaces a worn or broken locating/hinge pin to reduce play and restore proper movement. What it does:

• Secures and locates a pivot or hinge point so doors, panels, or components stay aligned
• Maintains correct spacing to prevent rubbing, binding, or uneven closing
• Restores stable movement when the original pin is worn, bent, or damaged
• Helps reduce rattling or excessive play at the pivot/hinge area

• Disconnect power and empty/remove any attached panels or doors before starting
• Use basic hand tools; support the component while removing/installing the pin to avoid damage
• Inspect mating parts (bushings, brackets) and replace if excessively worn
• Take care to control spring release to avoid injury

This part has been discontinued by the manufacturer and is no longer available.

Lower door hinge for refrigerators. Mounts at the bottom of the door to support weight and allow opening. Replace if cracked, bent, or worn out.

Note: This is a 1/4" x 1/4" compression elbow fitting without the nuts. See part# 4932JA3009A which is a 1/4" by 1/4" John Guess quick connector elbow. 

Specs: 7/16 x 20

This part has been discontinued by the manufacturer and is no longer available.

Replacement mounting screws that secure your cooktop to the countertop or cabinet. Essential when original screws are stripped, missing, or damaged during installation or service.