Parts for Ge DPVH880EJ0MV: 04 - Cabinet Parts

Fix a dryer that won't start rack dry cycle or shows error codes with this interlock relay. Direct replacement part restores proper rack drying function.

This hex washer-head screw secures dishwasher components like brackets, shields, and panels. Replacing a stripped or missing screw restores a tight fit and helps prevent vibration, rattling, and loose parts during operation.

• Fastens parts where a #10-16 x 1/2-inch hex washer-head screw is specified
• Secures brackets, panels, and assemblies to the tub or frame
• Helps resolve symptoms like loose panels, vibration, or rattling noises
• Restores proper hold when the original screw is stripped, missing, or damaged

• Disconnect power and shut off water to the dishwasher before servicing
• Match length and thread to the original; replace screws one at a time to maintain alignment
• Start threading by hand to avoid cross-threading; tighten snugly—do not overtighten, especially into plastic
• Verify no wires or hoses are pinched before reassembly

• Size: #10-16 x 1/2 inch
• Head: hex washer-head
• Type: AB tapping screw

Mounting screw for dryer drum support and internal components. Replaces lost, stripped, or damaged screws during repairs. Package of 12 screws included.

This adjustable gray foot supports and levels your dryer, allowing you to compensate for uneven floors. It screws into the dryer's base and can be raised or lowered to ensure the appliance sits level and stable. Replace this part if your dryer rocks, vibrates excessively, or appears tilted.

Replace your dryer's top cover panel if cracked, chipped, or discolored. This panel forms the main upper surface of your dryer cabinet exterior.

Gold-finish dryer top cover panel that restores the upper exterior surface. Replace if your original panel is cracked, dented, faded, or missing.

Replaces the rear mounting bracket that secures a leveling leg to your dryer frame. Needed when the original bracket is cracked, broken, or missing.

Rear bracket and leveling screw assembly.

This double fuse holder secures two inline/thermal fuses to protect appliance electrical circuits and keep components from damage. It provides a reliable mounting and connection point for fuses used in safety and overcurrent protection. What it does:

• Holds two compatible fuses in a single assembly for compact circuit protection
• Provides secure terminals for reliable electrical connections
• Helps isolate and replace blown fuses that interrupt power to components
• Commonly linked to symptoms like no power to a circuit, intermittent power, or a fuse that repeatedly blows

• One double fuse holder assembly

• Disconnect power to the appliance before inspecting or replacing the fuse holder
• Verify fuse type and ratings before reinstalling; replace only with fuses specified by the manufacturer
• Ensure tight, clean terminal connections to prevent arcing or overheating

This is a 30-amp, 250-volt fuse designed for use in dryers. It protects the dryer's electrical circuits from overcurrent conditions that could damage components or create a safety hazard. Replace this fuse if the dryer has stopped working entirely or if a multimeter test confirms the fuse has blown.

Dryer won't start or keeps tripping the breaker? A damaged terminal block disrupts power distribution. DIY repair typically takes 30-45 minutes.

Protective cover that shields the rear power connection terminals on your dryer. Replace if cracked, broken, or missing to prevent lint buildup and accidental contact with electrical connections.

Replacement strain relief bracket that secures the power cord at entry point. Needed when bracket is cracked, broken, or missing to restore safe cord routing.

Size: 8-32 t. Includes 12 screws.

Includes 12 screws. Size: 8-18 ab.

Mounting bracket that secures your dryer's main control board in place. Replace if cracked, bent, or broken to prevent board movement and maintain stability.