Parts for Kenmore 253.70013810 (25370013810, 253 70013810): Cabinet Parts

This is a genuine replacement mounting screw that secures appliance panels and components to restore stable fit and prevent rattling or loose parts. A simple, direct fix for hardware that has come loose or gone missing. What it does:

• Secures panels, trim, brackets, or components to maintain proper alignment and prevent movement
• Stops rattling or vibration caused by loose hardware
• Supports safe operation by keeping covers and guards fastened
• Used where the original mounting screw has worn, corroded, or been lost

• One mounting screw

• Turn off power to the appliance and unplug before servicing to avoid injury
• Use the correct screwdriver or driver bit to avoid stripping the head
• Replace only like-for-like;
• If you encounter damaged threads or stripped holes,

This evaporator temperature sensor monitors coil temperature so your refrigerator can control cooling and defrost cycles more accurately. Replacing a failed sensor restores proper temperature sensing and helps prevent overcooling or missed defrosts. What it does:

• Measures evaporator/coil temperature so the control board can regulate cooling and defrost timing
• Can cause warm refrigerator/freezer compartments or long run cycles when faulty
• May lead to frost buildup or failed defrosts if the control can't read coil temperature
• Works as a low-voltage thermistor input to the appliance control

• One temperature sensor (thermistor) as shown

• Disconnect power to the appliance before servicing
• Located near or on the evaporator coil; handle the sensor and wiring gently
• Follow OEM wiring and routing; secure sensor so it contacts the evaporator as intended
• Test the sensor with a multimeter per OEM resistance/temperature chart

Restores interior lighting in your refrigerator's fresh-food compartment. Replace when bulb burns out or dims. Verify fit with your model number.

If your refrigerator isn't cooling properly or runs constantly, the temperature sensor may need replacement. This part monitors internal temperature.

Refrigerator not cooling evenly or freezer too warm? The evaporator fan motor circulates cold air throughout both compartments for consistent temperatures.

Uneven cooling or warm spots in your refrigerator? The air duct plate assembly directs airflow for consistent temperatures. Moderate DIY repair.

Uneven cooling or warm spots in your refrigerator? The air duct plate assembly directs airflow for consistent temperatures. Moderate DIY repair.

This replacement cabinet insulation panel restores the refrigerator's thermal barrier to help maintain internal temperatures and reduce frost buildup. It fits behind interior panels to improve cold retention and overall efficiency. What it does:

• Replaces damaged or missing insulation that can allow warm air into the cabinet
• Helps reduce frost and ice buildup around the evaporator area
• Supports consistent internal temperatures for better food preservation
• Minimizes heat transfer from the room into the refrigerated compartment

• One insulation panel

• Disconnect power before beginning any repair to avoid electrical shock
• Remove interior panels or shelving as needed to access the insulation area
• Handle insulation with gloves to avoid irritation; avoid compressing or bunching material
• Reinstall panels and seals fully to ensure a proper thermal barrier; check fit before restoring power

Fix a noisy or warm refrigerator with this evaporator fan motor. Common repair for frost buildup and cooling issues. Moderate difficulty, 30-45 minutes.

Fix ice buildup or warm fridge issues with this evaporator temperature sensor. Controls defrost cycles and cooling accuracy. Straightforward replacement.

Fixing ice buildup in your freezer? The defrost sensor monitors temperature and triggers defrost cycles to prevent frost accumulation in your refrigerator.