Parts for Whirlpool WRF989SDAF00: 01 - Cabinet Parts

Fixes refrigerator temperature issues, non-working defrost, or fan problems. This electronic control board manages all refrigerator functions. DIY install.

Fix uneven door gaps or binding doors with this mullion pivot block. Restores proper door alignment and smooth operation. Simple DIY repair part.

Refrigerator door gasket creates an airtight seal to maintain temperature. Replace if worn, cracked, or causing warm temps. Confirm fit with model number.

Adjustable leveling leg for refrigerators and freezers. Installs at base corner to stabilize appliance on uneven floors. Replace if broken or stripped.

This replacement screw secures panels, brackets, and components inside appliances. Replacing a missing or stripped fastener restores a snug, rattle-free fit using the correct #8-18 thread and 5/8-inch length.

• Fastens covers, trims, brackets, and internal parts to the cabinet/frame
• Used wherever a #8-18 x 5/8 screw is specified
• Replace if the original is missing, corroded, stripped, or will not tighten
• Symptoms: loose or rattling panels, gaps, or hardware that backs out

• Disconnect power; shut off gas/water before servicing
• Match thread and length; start by hand to avoid cross-threading
• Use the correct driver bit and tighten snugly—do not overtighten
• Inspect and replace damaged clips or tabs before securing

Top-left door hinge assembly restores cabinet pivot and keeps your refrigerator door aligned for proper seal. Replace when door sags or won't stay closed.

Right-hand top hinge assembly for refrigerator doors. Replace if your hinge is cracked, broken, or worn to restore proper door alignment and support.

Mounting screw for refrigerator assembly. Secures components and panels in place. Replace if screw is stripped, missing, or no longer holding tight.

Black cover for bottom-mount refrigerators. Replaces cracked, broken, or missing covers. Direct-fit component for clean appliance appearance.

Replacement housing panel for refrigerators. Restores exterior appearance and protects internal components. Replaces cracked, broken, or missing cover.

This is a gray plastic cover that snaps over the right-side door hinge on the top of the refrigerator. It conceals the hinge mechanism and mounting hardware for a clean, finished appearance. Replace this cover if it is cracked, broken, discolored, or missing.

Cover for bottom-mount refrigerators. Replaces cracked, broken, or missing covers. Installs on exterior or interior surfaces for cosmetic protection.

This is a black plastic hinge cover that fits over the left-side door hinge on a refrigerator. It conceals the hinge hardware for a clean, finished appearance and helps protect the hinge from dust and debris. Replace this cover if it is cracked, broken, or missing.

Replaces cracked, broken, or missing refrigerator hinge cover. Protects door hinge hardware and restores finished appearance on exterior trim.

Secures door hinge to cabinet for proper alignment and sealing. Replace if missing, stripped, or loose to restore smooth operation. Confirm fit by model.

Refrigerator door hinge that mounts the door to the cabinet. Replace if the hinge is cracked, broken, bent, or causing door misalignment issues.

Black door hinge for bottom-mount refrigerators. Replaces cracked, broken, or worn hinges that cause doors to sag or not align properly. Essential part.

Gray door hinge for bottom-mount refrigerators. Allows smooth door opening and closing while maintaining proper alignment. Replace if cracked or worn.

This is a white corner trim cover used on the exterior of a refrigerator. It provides a finished appearance where panels or edges meet at a corner, covering gaps and raw edges. Replace this cover if it is cracked, discolored, or missing, which can detract from the appliance's appearance and allow dust or moisture to collect in the exposed seam.

Black plastic corner cover replaces damaged or missing exterior trim on your refrigerator. Restores finished appearance and protects edges from wear.

Replaces missing or damaged corner trim filler on your refrigerator. Restores a clean, finished look to interior or exterior cabinet seams and edges.

This smart electronic valve regulates on/off flow inside the appliance under command of the control system, helping the unit fill, dispense, or operate as designed. A precise, electronically driven valve is critical for consistent performance.

• Opens and closes when energized to start or stop flow to the connected system
• Coordinates with the control board for timed, accurate operation
• Helps prevent overfill or underfill conditions
• Common symptoms of a failing valve: no fill/flow, slow or intermittent flow, continuous flow when off, leaks from the valve body, or related fill/flow error codes

• Disconnect power and shut off the appliance's supply line upstream before servicing
• Keep towels or a container handy to catch residual fluid when lines are disconnected
• Transfer connectors and any reusable brackets from the old valve to the new one, matching orientation
• After installation, restore supply and power, then check all connections for leaks and proper operation

Hex head sheet metal screw secures panels, brackets, and internal components in refrigerators and freezers. Replace missing, corroded, or stripped screws.

Self-drilling screw secures panels, brackets, and trim without pre-drilling. Replace missing or stripped screws during appliance repair or reassembly.

Covers the lower front of your refrigerator, protecting internal components and directing airflow. Replace if cracked, broken, or missing.

Black front grille panel installs at the base of your refrigerator. Replace this toe kick cover if tabs are broken, panel is cracked, or the finish is worn.

Replace your refrigerator's cracked or missing base grille. This toe kick panel mounts across the bottom front to restore a finished look and protect components.

Mounting screw secures panels, brackets, and components to the appliance frame. Replace if stripped, rusted, missing, or damaged during service.

Black refrigerator door hinge that secures and supports the door for smooth opening and closing. Replace if cracked, broken, or worn to restore proper door alignment.

Refrigerator door hinge that mounts between the cabinet and door. Replace if your hinge is cracked, broken, or no longer holds the door securely in place.

Grey door hinge for bottom-mount refrigerators. Replaces cracked, broken, or worn hinges that cause misalignment or sagging doors. Installs on door frame.

This replacement screw secures specified refrigerator components—such as covers, brackets, and internal panels—so they stay properly mounted. Replace a missing, stripped, or corroded fastener to restore a tight, rattle-free fit and reliable operation.

• Provides the correct fastener for locations identified in your model's parts diagram
• Helps prevent looseness, vibration, and rattling of panels or brackets
• Replace if the head is stripped, threads are worn, or the screw is missing
• Symptoms can include loose parts, gaps, or noises from movement

• Unplug the refrigerator and shut off water if working near the ice maker or dispenser
• Match length and type to the original; follow your model's parts diagram for placement
• Start threads by hand to avoid cross-threading; tighten snugly without over-torquing, especially into plastic
• Keep track of screw positions; do not mix different screw lengths or styles

Fixes flickering, dim, or non-working LED lights inside your fridge. Restores full interior lighting. Moderate DIY repair, 30-45 minutes with basic tools.

Interior lights staying on or not working? This door switch controls refrigerator lighting and functions. Moderate DIY repair with video guide available.

Protective back cover panel for your refrigerator. Shields internal components from dust and damage. Replace if cracked, broken, or missing.

Fix a refrigerator door that won't close properly or binds when opening. This door cam pivot guide restores smooth alignment and movement.

Rubber grommet cushion for refrigerator panels. Protects wiring and components passing through metal openings. Replace if cracked, worn, or missing.

Replacement mounting screw for refrigerator panels, brackets, and internal components. Replace missing or stripped screws to restore secure fit.

Factory screw that secures panels, brackets, and hardware inside your refrigerator. Replace missing or stripped screws to eliminate rattles and loose fits.

Fix your refrigerator's weak water flow or leaking dispenser with this water tube replacement. Restores proper water routing from inlet to dispenser.

Transports water from supply line to icemaker. Replace if cracked, kinked, or leaking. Verify fit with your model number before ordering.