Parts for Generac 005993-0: Carburetor Parts

In gas-powered pressure or power washers, the carburetor is necessary to ensure the fuel is burning properly. The typical air to fuel ratio is between 12:1 and 15:1, and the carburetor keeps the balance where it needs to be for optimum performance levels from the equipment during use. Over time, the carburetor may clog, or the part will no longer function as it should. The signs of a failed carburetor include a poorly performing engine, smoke coming from the exhaust, overheating, backfiring, or difficulty starting the engine. In some cases, the part can be cleaned, while other times, the carburetor should be replaced.Remove the cover on the power washer with a screwdriver to replace a worn-out carburetor. Clamp the fuel line and note where the linkage is. Take off the air filter door. Remove the screws holding the carburetor. Replace with a new part and screw the carburetor back into position before removing clamps on the fuel line.This replacement carburetor is a genuine OEM part. It is sold as an individual piece. The carburetor is built of high quality, durable materials to ensure longevity. The replacement part is used in gas-powered power washers manufactured by Generac.

This carburetor gasket manages airflow around the motor. It is part of all carbureted engines and if it malfunctions, it allows air to be where it shouldn't. This alters the air to fuel ratio and can cause reduced performance or failure. If the gasket fails, it needs to be replaced promptly, because the engine will still run but will suffer damage if the gasket is allowed to leak air into or out of the motor. Replacing this part means taking apart the carburetor and cleaning all of the different components. It may also mean using the appropriate gasket sealer, though this varies based on the make and model of the engine or machine. This genuine OEM carburetor gasket is designed for Generac portable generators. It is shipped individually and will not include any other items, including sealants or oils.

This genuine carburetor insulator gasket is designed for use with select generators. The carburetor insulator gasket is designed to be installed between the carburetor and the engine block, providing an insulated seal that keeps air out and ensures that the engine is operating at peak performance. Gaskets are subject to a lot of pressure and high heat with regular use and will degrade or warp over time. This can result in leaks and other issues, so gaskets should always be replaced immediately. This OEM carburetor insulator gasket can provide an exact fit for compatible machines. This is a genuine product that is manufactured to exact standards by Generac. It is designed for use with select models of their generators. The gasket is made from durable composite materials and is sold as an individual unit. Gaskets are typically considered a part of routine maintenance and some people will purchase an extra unit to keep on hand in case of emergency repairs. This carburetor insulator gasket does not include any hardware or additional parts. A wrench set will be required for replacement. Always wear gloves when performing engine maintenance and repair. Repairs should never be performed on a hot engine.

The air cleaner gasket is placed between the air cleaner and the carburetor, which can help to ensure that the carb is getting the correct amount of air, while also providing some protection. The gasket can start to wear out eventually. It might become brittle and crack, or it might no longer sit properly, reducing its efficiency. If the air cleaner gasket has problems, it is important to replace it as soon as possible. Gaskets that are not working properly and that allow too much air to pass through could cause the engine to have trouble starting and operating. Replacing the filter is relatively simple. The air cleaner gasket is an authentic OEM part that is sold separately. This gasket is for use with power washers and generators from the Generac brand.