Parts for Ge PT9551BL2TS: Center Spacer Parts

This is the lower cooling fan motor assembly that circulates air around the oven cavity to prevent overheating of surrounding cabinetry and internal electronic components. It typically runs during and after cooking cycles to dissipate heat. Replace this fan motor if you hear unusual noises from below the oven, if the oven shuts off due to overheating, or if the fan fails to turn on during operation.

M4 hex nut secures panels, brackets, and assemblies in ranges and ovens. Replace if stripped, missing, or corroded to restore proper fit.

This is a cooling fan sensor board that monitors and controls the operation of the cooling fan in a range or oven. It helps regulate internal temperatures by signaling the fan to run during and after cooking to protect electronic components from overheating. Replace this board if the cooling fan does not turn on, runs continuously, or if you receive error codes related to the cooling fan or oven temperature regulation.

This replacement screw fastens panels, brackets, or trim inside your appliance. Swapping in a new screw restores a tight, secure fit and helps stop rattles, looseness, or misalignment caused by missing or damaged hardware.

• Secures panels, brackets, or trim to the appliance chassis
• Helps maintain proper alignment and spacing of components
• Replaces missing, rusted, or stripped hardware
• Helps resolve loose panels/handles, vibration, or rattling noises

• Disconnect power before servicing; for gas appliances, also shut off the gas supply
• Match the screw to the original location; start threads by hand to avoid cross-threading
• Use the appropriate driver and tighten snugly without overtightening
• Inspect the mounting hole or clip for damage and address as needed before reassembly

Black. 8-18 AB HXW 3/8