Parts for Kitchenaid 5KSM160APSACA0: 01 - Color Variation Parts

A replacement housing that secures and protects the appliance's internal components and mounting points. Restores structural support and helps reduce vibration or movement caused by damaged or cracked housings. What it does:

• Provides a stable mounting surface for internal assemblies and fasteners
• Protects internal parts from debris and accidental contact
• Restores proper alignment to reduce noise, vibration, and movement
• Addresses visible cracks, broken mounting tabs, or warped housing edges that compromise fit

• One housing

• Disconnect power and water before beginning any repair
• Handle edges carefully; use gloves to avoid cuts from sharp sheet-metal or plastic
• Basic hand tools required; follow the appliance service manual for disassembly/reassembly
• If mounting tabs or adjacent parts are damaged, inspect and replace those items as needed for a complete repair

Motor housing for stand mixers. Encloses and protects internal motor components. Replace if cracked, broken, or damaged from impact or wear.

Replaces the front grille housing on your stand mixer. Needed when the original is cracked, warped, discolored, or missing. Almond creme finish.

Empire red housing for stand mixers. Replaces cracked, chipped, or discolored exterior covers. Restores appearance and protects internal components.

Replace the end cover on your stand mixer when the original is cracked, broken, or missing. This cosmetic panel installs on the motor housing end.

Replacement access panel cover for stand mixers. Shields internal wiring and controls while restoring exterior appearance. Replaces cracked or missing covers.

Factory-matched Almond Crème touch-up paint for stand mixers. Covers small chips, scratches, and worn spots on Almond-finish appliances for a cleaner look.

Fix mixer wobbling or grinding noises with this planetary gear assembly. Essential for smooth mixing action. Moderate repair with periodic greasing.

Fixes grinding noise and erratic mixing. This planetary gear assembly restores smooth rotation in your stand mixer. Moderate DIY repair with proper tools.

Mixer not turning or making grinding noises? This gearcase assembly houses the planetary gears that drive your attachments. Moderate DIY repair.

Decorative grille that covers the control area on your stand mixer. Replace if cracked, damaged, or loose to restore a clean, finished appearance.

Almond Creme finish panel for stand mixers. Restores exterior appearance when original panel is scratched, worn, or discolored. Direct replacement.

This pedestle is the replacement agitator post that supports and centers the washer agitator, restoring proper agitation and load stability for top-load washers. It's a direct-fit part used during agitator assembly repairs. What it does:

• Centers and secures the agitator on the transmission shaft for effective wash action
• Helps transmit agitation motion from the transmission to the agitator
• Commonly replaced when the agitator wobbles, slips, or does not rotate properly
• Restores stable operation without requiring a full agitator or transmission replacement

• One pedestle (agitator post) as shown

• Disconnect power to the washer before beginning any repair
• Remove agitator per manufacturer instructions to access and replace the pedestle
• Use appropriate hand tools; keep fasteners organized for reassembly