Parts for Ge DCLR333ET0WW: 01 - Control Assembly Parts

Installation instructions and care guide manual for your dryer. Provides setup procedures, operating guidelines, and maintenance information.

This mini manual actuator is the small lever used to operate a dispenser or control linkage, restoring reliable manual control and reducing leaks or intermittent operation. It's a direct-replacement style part designed for quick service. What it does:

• Engages the dispenser or control linkage so the device dispenses water/ice when pressed
• Replaces worn, broken, or bent levers that cause poor contact or inconsistent operation
• Helps stop unintended flow or drips caused by damaged actuator hardware
• Works as the user-facing manual control for dispenser mechanisms

• One mini manual actuator/lever

• Disconnect power and water supply before beginning any service
• Remove access panels or dispenser bezel to reach the actuator
• Verify correct actuator orientation and engagement with the dispenser linkage when installing

White. Left hand side

White. Right had side

Dryer timer knob control for selecting drying cycles. Replace if your original knob is cracked, broken, stripped, or missing from the control panel.

8 - 18 ab flt 5/8 sn wh

Control knob and clip assembly for dryer or washer. Attaches to control shaft to set cycles and settings. Replace if cracked, broken, or missing.

Dryer won't start when you press the button? This rotary start switch activates your dryer cycle. Simple DIY fix in minutes with basic tools.

The Knob Clip is an OEM part for GE washing machines and dryers. This small but crucial component is designed to secure the control knob to the appliance's control panel.  

Over time, knob clips can wear out or break due to frequent use or accidental damage. When this happens, the control knob may become loose, fall off easily, or fail to engage the control panel properly, making it difficult to set the appliance to the desired cycle or function.

Symptoms of a bad Knob Clip include:

• The control knob is loose or falls off the panel easily.
• Difficulty in adjusting settings due to a loose knob.
• The knob does not stay in place or slips when turned.

This OEM GE part is also compatible with Hotpoint, RCA, and some Kenmore models.

Fix a dryer that won't advance through cycles, runs too long, or won't shut off. This timer control restores proper cycle timing and shutoff.

Size: 8-18 b.

Size: 8-32 t. Includes 12 screws.

These GE screws are a 12-pack of OEM replacement parts responsible for securing and fastening various components and panels in a GE range or oven. These screws are designed with a hexagonal head, which allows for the use of a compatible wrench or socket for tightening. They are commonly used to attach sheet metal panels, brackets, and other parts within the appliance, ensuring that these components remain securely in place during operation.

This part fixes the following symptoms:

• Loose or wobbly parts or panels within the appliance's interior or exterior
• Panels or components falling out of place, creating gaps or exposing internal parts
• Unusual noises or rattling sounds during the appliance's operation

The GE screws can also be used on Hotpoint, RCA, and Kenmore/Sears appliances.