Parts for Kitchenaid KEWS175BPA00: 01 - Control, Door And Drawer Parts

This ground screw secures the appliance's grounding wire or strap to the chassis or terminal area, creating a reliable bonding point. Replace a missing or damaged screw to restore a proper ground connection during installation or service.

• Provides the designated bonding point for the grounding wire/strap
• Fastens to the frame or terminal area using 8-32 machine threads
• Helps maintain a consistent ground path for safe operation
• Typical reasons to replace: stripped head/threads, corrosion, or a missing screw

• Disconnect power at the breaker or unplug the appliance before servicing
• Route the ground wire/strap to the specified grounding location
• Start threads by hand to avoid cross-threading; tighten snugly without overtightening
• Ensure the ground connection is secure and complies with local electrical codes before restoring power

This front door is the outer panel that replaces a damaged or dented appliance door, restoring appearance and sealing performance. It ships ready to attach to the existing inner components for a clean factory look. What it does:

• Replaces a dented, cracked or cosmetically damaged outer door panel.
• Restores the appliance's sealed closure and helps prevent drafts or heat loss.
• Returns the appliance to a uniform exterior finish for improved appearance.
• Works with your existing inner door components and hardware when undamaged.

• One front door outer panel.

• Designed to attach to the existing inner door assembly; inner components and hardware are present before ordering.
• Follow manufacturer service manual for proper removal and reassembly to avoid damage.
• Disconnect power (and water, if applicable) and take safety precautions before beginning.
• If inner components, glass, or hinges are damaged, replace those parts as needed.

A 27-inch replacement refrigerator door handle that restores a secure grip and fresh appearance. Designed to match factory fit and finish for a clean, usable door surface. What it does:

• Provides a sturdy handhold for opening and closing the refrigerator door
• Restores proper clearance and alignment when the original handle is cracked or broken
• Helps prevent sharp edges and reduces risk of cuts from damaged handles
• Improves the cabinet's appearance when the original handle is worn or faded

• One replacement 27-inch door handle

• Remove power to the appliance or open doors fully to prevent pinching during installation
• Use appropriate hand tools; avoid overtightening fasteners to prevent cracking
• Keep screws and small parts secure—inspect existing mounting points for damage before attaching

Color: Stainless

This control knob replaces a cracked or missing knob on your appliance's control panel. It restores positive engagement with the underlying control so you can select settings reliably and keep the front of the unit looking complete.

• Attaches to a keyed or D-flat shaft to operate the switch, valve, or timer underneath
• Allows you to choose cycles, temperatures, or burner levels as designed
• Common symptoms: knob cracked, stripped, loose/spins without engaging, falls off, or missing pointer
• Helps restore normal operation and a finished, uniform appearance

• Disconnect power; for gas appliances, also shut off the gas supply
• Pull the old knob straight off the shaft—do not pry against the bezel or panel
• Align the new knob's opening with the shaft and press firmly until fully seated
• Test the control to confirm proper engagement and function

This replacement screw secures appliance panels and components so they stay tight and aligned during use. Replacing a missing or damaged screw restores a solid fit and helps eliminate rattles, loose trim, or shifting parts.

• Fastens brackets, panels, trim, or components to the appliance chassis
• Helps correct loose or missing hardware after vibration or service
• Replaces stripped, rusted, or broken screws
• Can reduce rattling noises or misaligned parts caused by missing fasteners

• Disconnect power; for gas appliances, also shut off the gas supply
• Support the part being fastened; start threads by hand to avoid cross-threading
• Use the correct driver size; tighten snugly without overtightening
• Replace hardware with the exact part number to ensure proper fit