Parts for Ge CHS985SEL1SS: Control Panel & Cooktop Parts

The Range Top Glass and Front Support Kit is an OEM replacement part for GE electric ranges. As the protective surface above cooktop burners and the frame securing the glass panel, this kit plays an integral role. 

Symptoms of a bad glass

Fix loose or misaligned control panel buttons and knobs. This support bracket secures your range's control console for reliable operation and proper fit.

This indicator sleeve is a small control-knob marker that restores a clear position marker and snug fit on the control shaft for reliable setting selection. It improves dial visibility and stabilizes the knob during use. What it does:

• Covers and centers the control shaft so the knob sits straight and turns smoothly
• Provides a visible pointer for selecting temperature or power settings
• Replaces cracked, worn or missing sleeves that make knob position hard to read
• Helps eliminate wobble or looseness between the knob and control shaft

• One indicator sleeve

• Disconnect power to the appliance before servicing
• Remove the control knob (pull straight off) to access the sleeve
• Press the sleeve onto the shaft by hand until fully seated; no special tools generally required
• If the knob or shaft is damaged, inspect and replace as needed for secure fit

This lower oven warming element heats the oven's warming/holding compartment so food stays warm until serving. Replaces a damaged or non-heating lower element to restore consistent low-temperature operation. What it does:

• Heats the oven's warmin

This induction cooktop element replaces a failed high-power burner to restore normal cooking performance on compatible induction ranges. It provides the heating coil assembly required for fast, responsive induction heating. What it does:

• Replace

Wing knob kit used for panelization installation on select range models. Replace missing, stripped, or damaged wing knobs to secure trim panels properly.

Trim kit for gas ranges. Installs around cooktop or control panel to cover gaps and provide a finished appearance. Replace if cracked or missing.

Stainless steel #8-18 x 3/8" screw secures panels, brackets, and components in ranges, cooktops, and ovens. Replace if stripped, missing, or corroded.

Induction control and gasket kit manages cooking element power on electric ranges. Replace if elements won't heat, respond erratically, or show error codes.

Seals the air duct beneath your induction cooktop to maintain proper airflow and prevent heat or steam leakage. Replace when worn or damaged. Verify fit by model number.

Replacement 8-18 x 5/16 screw secures range panels, brackets, and components. Needed when original fastener is stripped, missing, or damaged.

Seals the gap between your range body and control panel to contain heat and prevent spills from entering internal components. Replace if heat escapes or moisture gets inside. Confirm fit by your model number.

The Cooling Fan Sensor is an OEM replacement part for GE ovens and ranges. It is a critical component that monitors and regulates the operation of the cooling fan, ensuring proper ventilation and temperature control within the appliance.

Sympto

The Blower Tangential is an OEM component designed specifically for GE ranges. Located near the top of the oven cavity, this tangential blower circulates exhaust air out of the oven and above the cooktop during and after cooking cycles.  

A temperature probe that senses oven temperature and sends readings to the control board so the appliance can regulate cooking heat. Replaces a failed or intermittent probe to restore accurate temperature feedback. What it does

• Measures internal