Parts for Electrolux EI30MO45GSA: 05 - Control Panel,Door,Mics Parts

If your microwave stops mid-cycle, won't heat, or keeps resetting, the control board likely failed. This board regulates power to all microwave functions.

Control panel assembly with integrated touch overlay for your microwave. Mounts on the front face. Replace when buttons are cracked, worn, or unresponsive.

Control panel assembly with integrated touch overlay for your microwave. Mounts on the front face. Replace when buttons are cracked, worn, or unresponsive.

Replace your microwave's door open button if the original is cracked, broken, or missing. This button installs on the control panel for manual door release.

Replacement tension spring for microwave doors and buttons. Restores proper movement when original spring is worn, broken, or missing. Installs at control panel.

Mounting screw for microwave panels, trim, and brackets. Replaces lost or damaged fasteners to restore secure alignment and eliminate rattles or loose components.

Fix a microwave door that won't close or sticks when opening. This latch hook secures the door mechanism for proper sealing. DIY repair in under an hour.

Replacement spring for microwave door latch mechanism. Restores return tension so the latch engages and releases correctly. Needed when spring is broken or worn.

Replacement door panel for your microwave. Installs on the outer door assembly to restore appearance. Order when your panel is cracked, damaged, or worn.

Door seal for microwaves. Installs around the door perimeter to create an airtight closure. Replace if cracked, torn, or no longer sealing properly.

Replaces the exterior trim frame on your microwave door. Needed when the original frame is cracked, bent, melted, or missing for a clean, finished look.

This replacement electrical wire restores a damaged or faulty connection in compatible Frigidaire appliances, helping re-establish reliable power or signals to components. Use it when wiring is cracked, melted, or showing corrosion. What it does:

• Replaces a worn or damaged single conductor wire used in internal appliance circuits
• Restores continuity to fix intermittent power, component failure, or nonfunctional controls
• Prevents shorts caused by exposed or frayed insulation when installed correctly
• Matches OEM routing and connection points when used with the original harness and terminals

• Disconnect power before inspecting or replacing any internal wiring
• Verify wire routing and terminal fit with the original part; secure with appropriate connectors or clips
• Do not splice with incompatible gauge or insulation types; follow appliance wiring diagrams