Parts for Frigidaire DGMV174KFA: 05 - Control Panel / Door / Misc Parts

Fix turntable running on its own, flashing lights, or blank display. This electronic control board manages your microwave's interface and functions.

This is a microwave control cover that houses and protects the control board components. It provides access to the electronic controls while shielding them from moisture and debris. Replace this part if the control cover is cracked, missing, or if you need to replace internal control components and require the complete assembly.

3mm x 8mm screw secures trim, panels, and brackets inside your microwave. Replace missing or stripped screws to restore proper fit and alignment.

Complete preassembled microwave door. Replaces cracked, dented, or warped doors. Includes frame, glass, handle, and latch components for full restoration.

Complete preassembled microwave door. Replaces cracked, dented, or warped doors. Includes frame, glass, handle, and latch components for full restoration.

Microwave won't start or light stays on when door closes? A faulty door latch prevents proper switch engagement. DIY repair typically takes 15-20 minutes.

Replacement spring for microwave door latch mechanism. Restores return tension so the latch engages and releases correctly. Needed when spring is broken or worn.

A protective cover that helps contain microwave radiation around the door seal area for safety. Located inside the microwave door frame along the edges. Replace if you notice visible damage, warping, or gaps that could allow microwave leakage during operation.

Mounting screw for microwave installation and assembly. Replaces lost, stripped, or damaged screws that secure panels, brackets, or components.

Hardware kit for mounting microwave to wall and cabinet. Includes screws, bolts, and washers for secure installation. Replaces lost or missing fasteners.

A replacement unified-thread screw used to secure appliance panels and internal components. Provides a direct fastener to restore secure attachment when original screws are missing, damaged, or corroded. What it does:

• Fastens panels, brackets, trim pieces, and other appliance components that use a unified-thread screw.
• Restores secure mounting to reduce rattling, movement, or misalignment of parts.
• Replaces stripped, rusted, or missing screws to help maintain safe operation.
• Works where the appliance's service manual or parts diagram specifies a unified-thread fastening point.

• Disconnect power and water before servicing for safety.
• Use the correct screwdriver or bit to avoid stripping the head; install by hand until started, then snug—do not overtighten.
• Replace like-for-like: match thread type and length to the removed screw to ensure proper fit and function.
• If other fasteners show corrosion or damage, inspect nearby hardware and replace as needed.

Microwave mounting screw used to secure internal components or attach the unit to cabinets. Replace if screw is stripped, missing, or broken.

Replacement washer for your microwave. Installs between components to provide spacing or cushioning. Order a new one if the original is missing, worn, or damaged.

Cosmetic badge that attaches to the microwave exterior. Replaces a cracked, faded, or missing badge to restore the original branded appearance.