Parts for Frigidaire FFBD1821MB0A: 03 - Control Panel / Door Parts

Dissolves limescale, mineral deposits, and odor-causing residues from dishwasher tub and spray system. Use monthly to maintain peak cleaning performance.

The Touchpad is an OEM part for Frigidaire dishwashers. As the primary interface through which users select cleaning cycles, check status, and adjust preferences.

Causes of a bad touchpad can include wear and tear over time, exposure to moisture or impacts that damage electronic components, or malfunctions due to age.

Symptoms of a bad touchpad include:

• Buttons not responding or responding incorrectly
• Display fading, pixels not working, or full screen failure
• Inability to start or stop cycles
• Failure to alert of completed cycles

This OEM Frigidaire part is also compatible with Electrolux, Gibson, Kelvinator and some Kenmore models.

Dishwasher door won't start cycles or stops mid-wash? This door-mounted switch detects when the door is open and controls operation. Easy DIY fix.

Fix a dishwasher that won't start or stop when the door opens. This door latch assembly replacement takes about 10 minutes with basic tools.

Genuine mounting bolt for dishwashers. Secures internal brackets, panels, and assemblies to the chassis. Replace if missing, stripped, or damaged.

This replacement mounting screw secures panels and small components in refrigerators and freezers, restoring proper fit and reducing rattles or loose parts. Use it to replace a missing or damaged fastener for a secure repair. What it does:

• Secures trim, panels, brackets or small components to prevent movement and noise
• Restores proper alignment and fit for doors, panels or internal assemblies
• Prevents further wear or damage from loose parts
• Common symptom: loose panel, rattling, or missing fastener after service or impact

• Disconnect power and remove any stored items before accessing internal panels
• Use the correct screwdriver or bit to avoid stripping the head
• Thread carefully and tighten just until snug; avoid overtightening to prevent cracking or thread damage
• Keep removed screws in a labeled container during disassembly to ensure correct reassembly

Dissolves limescale, mineral deposits, and odor-causing residues from dishwasher tub and spray system. Use monthly to maintain peak cleaning performance.

Replace your dishwasher's door hinge if it's cracked, broken, or causing misalignment. This structural component mounts to the frame and supports door movement.

Retaining ring clip secures dishwasher components in place. Replace if broken, cracked, or missing to prevent parts from loosening during cycles.

Replace your dishwasher's door hinge if it's cracked, broken, or worn. This structural part secures and supports the door panel during open and close cycles.

Fix a broken or cracked detergent dispenser with this dishwasher dispenser assembly. Restores proper detergent release and door appearance.

Protective guard for your dishwasher. Shields internal components from damage. Replace if cracked, broken, or missing to maintain proper protection.

A single replacement screw used to secure interior or exterior appliance components. Restores proper fastening where the original screw is lost, stripped, or damaged so panels and assemblies stay in place. What it does

• Fastens panels, brackets, trim pieces, or small assemblies to the appliance
• Replaces missing, stripped, or corroded screws that cause rattling or loose parts
• Helps restore proper alignment and prevents further wear from loose components
• Works wherever the OEM screw specification matches

• One screw (quantity: 1)

• Use the matching screw location and thread engagement; do not force a mismatched screw
• Disconnect power and remove any food or water before servicing areas with electrical or water connections
• Hand-start the screw to avoid cross-threading, then tighten snugly—avoid over-torquing

Rubber bumper block for dishwasher racks. Installs on rack ends to cushion and protect against cabinet damage. Replace when cracked, worn, or missing.

The Side Mount Kit is an OEM replacement part for Frigidaire dishwashers. It contains mounting brackets, screws, and other hardware required to securely install the dishwasher against cabinetry in a side-by-side configuration. Proper attachment is necessary for stability and safety during operation. 

Symptoms of damaged or missing mounting hardware include:

• Excessive movement or rocking of the dishwasher body
• Potential detachment from cabinets  
• Screws pulling loose from repeated vibrations
• Improper door alignment causing difficulty closing fully

Causes related to normal wear over extended use periods. Damage may occur if weight is applied during improper lifting or installation attempts.  

Compatible models include Electrolux, Gibson, and select Kenmore units.

Dissolves limescale, mineral deposits, and odor-causing residues from dishwasher tub and spray system. Use monthly to maintain peak cleaning performance.