Parts for Maytag JWD3027ES00: 02 - Control Panel And Drawer Parts

Replacement rack for warming drawer. Installs inside drawer cavity to hold dishes and pans. Order if original rack is bent, warped, or missing.

Warming drawer door gasket seals the drawer to maintain consistent temperature and prevent heat loss. Replace if torn, cracked, or loose fitting.

This replacement screw secures appliance panels and components so they stay tight and aligned during use. Replacing a missing or damaged screw restores a solid fit and helps eliminate rattles, loose trim, or shifting parts.

• Fastens brackets, panels, trim, or components to the appliance chassis
• Helps correct loose or missing hardware after vibration or service
• Replaces stripped, rusted, or broken screws
• Can reduce rattling noises or misaligned parts caused by missing fasteners

• Disconnect power; for gas appliances, also shut off the gas supply
• Support the part being fastened; start threads by hand to avoid cross-threading
• Use the correct driver size; tighten snugly without overtightening
• Replace hardware with the exact part number to ensure proper fit

Replaces dented or damaged outer door panel on your warming drawer, restoring appearance and proper sealing. Confirm fit with your model number.

Color: Stainless

Warming drawer indicator light bulb illuminates control panel to show unit is operating. Replace when light fails or flickers. Verify fit with model number.

Replace your warming drawer's pan rail if it's cracked, bent, or broken. This rail guides and supports the pan as it slides in and out of the drawer cavity.

This is a small spacer used behind or around the indicator light lens on a range or oven control panel. It ensures the lens sits at the correct depth and position for proper alignment and light visibility. Replace this spacer if the indicator light lens is recessed too far, sits unevenly, or the original spacer is cracked or lost.

This small clip secures the indicator light lens in place on a warming drawer. It snaps onto the lens housing to hold the translucent cover over the indicator bulb. Replace this clip if the indicator light lens is loose, keeps falling out, or the original retainer is broken or missing.

Small mounting spacer that maintains proper positioning between internal range components. Replace if cracked, worn, or missing to restore alignment.

Replacement 8-32 x 3/8 mounting screw for securing panels, brackets, and covers to appliance frames. Restores tight fit when original is missing or worn.