Parts for Electrolux EW30IS6CJSA: 03 - Control Panel / Induction Unit Parts

This is an electronic noise filter board that suppresses electrical interference generated by the range's components, preventing it from affecting the control board and other electronics. It is typically mounted near the power supply wiring inside the range. Replace this filter if you experience erratic control panel behavior, display flickering, or if the board shows visible burn marks or damage.

Fix F90 error codes, intermittent operation, or unresponsive oven controls. This range control board restores full electronic function to your oven.

Replacement mounting screw for ovens and ranges. Secures panels, trim, or brackets to the appliance frame. Needed when original is stripped or missing.

Replace your electric range's control panel trim if cracked, chipped, or broken. This cosmetic trim piece covers the front panel area for a clean finish.

Fix F11, F14, or E15 error codes and unresponsive controls. This electronic control board restores oven temperature regulation and display functions.

Range won't turn on or display shows incomplete numbers? This electronic control board manages cycles and user inputs. Moderate DIY repair, 1-2 hours.

This is the power supply board that provides regulated electrical power to the oven control board and other electronic components in the range. It converts incoming voltage to the levels needed by the control circuitry. Replace this board if the range display is blank, flickering, or if the oven and burner controls are completely unresponsive despite the unit receiving power.

Mounting screw for electric range, oven, or wall oven assembly. Secures internal components and panels. Replace if stripped, missing, or damaged.

Replacement mounting screw for refrigerators, ovens, ranges, and cooktops. Secures interior panels, components, and trim. Needed when original is stripped, missing, or damaged during repair.

Secures and organizes wires inside your appliance. Replace if broken, loose, or missing to prevent wire damage. Verify fit with your model number.

Replacement #8 x 0.500 inch screw for securing panels, trim, and brackets in appliances. Needed when original fasteners are stripped, lost, or missing.

This is a replacement screw used to secure appliance panels and components. It restores proper fastening so panels, trim, or assemblies stay tight and reduce vibration or rattling. What it does

• Fastens panels, brackets, or trim to the appliance chassis
• Helps stop loose or vibrating panels and trim pieces
• Restores proper alignment where a missing or stripped screw causes gaps or movement
• Use when the original screw is missing, damaged, or corroded

• One replacement screw as shown

• Disconnect power to the appliance before starting any repair
• Use the correct screwdriver or bit to avoid stripping the screw head
• Tighten until snug; avoid over-torquing which can strip threads or crack plastic
• Keep removed screws in a safe place; this screw matches the original before installation

Fastens panels, brackets, and covers inside your range or oven. Replace this screw if missing, stripped, or rusted to secure components properly.

This replacement screw secures appliance panels, brackets, and internal components. It restores a tight, rattle-free fit and proper alignment when an original fastener is missing, stripped, or corroded.

• Fastens metal or plastic parts to the cabinet/frame
• Helps maintain alignment and reduce vibration or rattling
• Direct replacement for lost, damaged, or rusted hardware
• Keeps covers and brackets safely in place

• Disconnect power before servicing; for gas appliances, also shut off gas supply
• Match one-for-one with the original screw; verify length/type before installation
• Start threads by hand to avoid cross-threading; tighten snugly without overtightening
• Use the correct driver bit to prevent stripping the screw head