Parts for Bosch HEIP054U/05: Control Panel Parts

If your range controls aren't responding or the heating element won't turn on, this push-button switch restores reliable front-panel operation.

Fix burners that won't turn on or have dead spots with this electric range infinite switch. Controls cooktop burner heat from low to high power levels.

Range not responding to controls or failing to start? This electrical switch completes the circuit to restore power. Simple repair for intermittent operation.

Sheet panel for wall ovens and ranges. Installs inside the oven cavity as a structural component. Replace if cracked, damaged, or missing.

Fix a blank, flickering, or unresponsive oven display. This electronic control module restores touchpad function and temperature settings. DIY-friendly repair.

Mounting screw secures internal oven components and panels. Replace if stripped, missing, or damaged during service. Essential hardware for reassembly.

Rubber grommet cushions and seals range components, reducing vibration and protecting wiring. Replace when cracked, torn, or loose. Confirm fit with model.

Fix a broken or missing stove control knob with this surface element control knob. Restores heat adjustment for your electric range burner. Easy DIY fix.

Oven overheats or shows E115 error? The temperature limiter (safety thermostat) may have failed. Moderate difficulty repair requiring careful disassembly.

Oven door won't latch or stays locked? This door latch secures your oven door during cooking and prevents accidental openings. Moderate DIY repair.

This cable harness routes electrical signals between dishwasher components to restore proper control and power delivery. It replaces a damaged or broken wiring assembly so affected circuits can communicate and operate reliably. What it does:

• Connects control board, sensors, pumps and other internal components to carry power and signals
• Restores intermittent or lost power to specific assemblies caused by frayed or broken wires
• Helps eliminate error codes or failures tied to open or shorted harness connections
• Prevents arcing and poor connections that can cause unreliable operation

• One cable harness assembly as pictured

• Only install after disconnecting power to the appliance to avoid shock or damage
• Inspect mating connectors and pins for corrosion or damage before connecting
• Route harness away from sharp edges, moving parts and hot surfaces to avoid future wear

Fix intermittent power or electrical faults in your range with this cable harness. Routes power and signals between control and components. Direct fit.

A single electrical replacement lead that restores a broken or damaged connection inside your appliance, allowing a circuit or component to regain reliable power and operation. What it does:

• Carries electrical current between components to complete appliance circuits
• Replaces frayed, cut, or burnt wiring that causes intermittent power or failure
• Helps stop arcing, sparks, or loose-connection symptoms when installed correctly
• Restores a specific circuit path so affected features or a component can function again

• Disconnect power to the appliance before inspecting or replacing wiring
• Match the wire routing, length, and terminal connections exactly to the original
• Use correct crimping or soldering and proper insulation to prevent shorts