Parts for Electrolux FFLE3911QW0: 04 - Control Panel Parts

This electronic control board is the appliance's central circuit board, interpreting inputs and directing power to key components. Replacing a failed board can restore normal operation, responsive controls, and consistent performance after erratic, dead, or intermittent behavior.

• Processes user inputs and sensor signals to coordinate functions
• Manages timing, indicator/display logic, and safety interlocks as designed
• Distributes power to loads
• Common failure symptoms: no power/display, unresponsive buttons, random cycling/beeping, or error codes

What's included: 1 electronic control board Install notes:

• Disconnect power at the breaker or unplug the appliance before servicing
• Handle the PCB by the edges and use anti-static protection
• Photograph wiring and transfer connectors one at a time to the new board
• Some models require programming or a diagnostic reset; follow the unit's tech sheet/service manual

Replacement control knob for laundry center. Attaches to control shaft for selecting settings. Replace if original is cracked, loose, missing, or stripped.

Fix intermittent power issues or control failures in your laundry center with this wire harness. Restores reliable electrical connections between components.

This is an electronic control board designed for use in a combination washer/dryer or laundry center unit. It manages the user interface and cycle selections, communicating your inputs to the main control system. Replace this board if the display is blank or unresponsive, buttons fail to register, or the unit does not start or respond to cycle selections.

The Cycle Selector Switch is an OEM part for Frigidaire washers and dryers. It is a component that allows you to choose and control different cycles and settings during the laundry process. The cycle selector switch is typically located on the control panel of the washer or dryer.

Causes of a faulty cycle selector switch can include regular wear and tear, electrical malfunctions, or physical damage. These factors can result in issues such as the switch not responding or functioning properly, difficulty in selecting or changing cycles, or the appliance not starting or stopping as desired.

Symptoms of a bad cycle selector switch may include:
Inability to select or change cycles
Unresponsiveness or inconsistency in switch operation
Error codes or failure to start or stop the appliance

Exterior control panel trim that secures buttons, knobs, and display in place. Replaces cracked, broken, or loose console trim on your laundry center.

Pan head mounting screw for dryers. Secures internal components and panels. Replace if stripped, missing, or damaged during appliance maintenance.

Wire harness for laundry center units. Connects electrical components between washer and dryer sections. Replace if wires are frayed, damaged, or connectors broken.

Secures and organizes wires inside your appliance. Replace if broken, loose, or missing to prevent wire damage. Verify fit with your model number.

Fix a laundry center that won't respond to cycle selections or temperature settings. This electrical switch restores control circuit function when worn.

Dryer won't start or smells like burning? A melted or loose terminal block where the power cord connects is often the cause. Easy 20-minute repair.