Parts for Frigidaire FDB1050REB5: 03 - Control Panel Parts

Dissolves limescale, mineral deposits, and odor-causing residues from dishwasher tub and spray system. Use monthly to maintain peak cleaning performance.

Color: Black

Connects door springs to the dishwasher door hinge for smooth, balanced opening and closing. Replace if cracked, broken, or missing due to wear or damage.

Replace cracked or bent dishwasher door hinges. Mounts on left and right sides of the door frame to support the door weight and ensure smooth operation.

Replace cracked or bent dishwasher door hinges. Mounts on left and right sides of the door frame to support the door weight and ensure smooth operation.

Dispenser door won't close or latch? Replace the detergent dispenser assembly. DIY repair takes 5-10 minutes with video guide. Fixes stuck or broken latch.

Dissolves limescale, mineral deposits, and odor-causing residues from dishwasher tub and spray system. Use monthly to maintain peak cleaning performance.

Mounting screw for dishwasher assembly. Secures internal components and panels. Replace if missing, stripped, or corroded during maintenance or repair.

Replacement dishwasher door hinge pin that connects the door to the frame. Needed when the original pin is worn, bent, or broken causing door alignment issues.

This is a small bearing that fits onto the door hinge pin of a dishwasher. It allows the door to pivot smoothly when opening and closing, reducing friction and wear on the hinge assembly. Replace this bearing if the dishwasher door feels stiff, squeaks during operation, or does not stay open at the desired angle.

Plastic dispenser mounting screw for dishwashers. Secures detergent dispenser assembly to door. Replace if stripped, cracked, or missing.

Replacement mounting screw for dishwasher panels and internal components. Secures brackets and chassis parts. Replace stripped, missing, or damaged hardware.

Replacement mounting screw for dishwasher panels and internal components. Secures brackets and chassis parts. Replace stripped, missing, or damaged hardware.

This thermistor is the dishwasher's temperature sensor. It reports water temperature to the control so the heater and cycle timing are managed correctly, helping restore reliable wash performance and more consistent drying.

• Monitors water temperature in the tub/sump and sends readings to the control board
• Helps the control regulate heater operation and determine cycle progress/timing
• Failure can result in no heat or poor drying
• May cause unusually long/short cycles or temperature-related fault codes

• Disconnect power at the breaker and shut off the water supply before servicing
• Access is typically from the toe-kick/base area or sump; remove the lower access panel as needed
• Release the locking tab/clip, remove the sensor, and ensure the existing seal/O-ring is properly seated; install the new sensor fully to prevent leaks
• Reconnect the wire harness, restore power, and run a test cycle to check for leaks and proper heating

This side mounting bracket kit includes the hardware needed to secure a dishwasher to the adjacent cabinetry from the sides rather than from the countertop. It is commonly used in kitchens with granite, stone, or other countertops where top-mounting screws cannot be used. Replace this kit if the original brackets are bent, broken, or missing, causing the dishwasher to shift or slide during operation.

Dissolves limescale, mineral deposits, and odor-causing residues from dishwasher tub and spray system. Use monthly to maintain peak cleaning performance.