Parts for Frigidaire FEB398CESC: 02 - Control Panel Parts

The oven control board is located behind the front panel and manages all oven functions including temperature, timing, and cooking modes. Replace it if the display is blank, buttons don't respond, or if the oven won't heat to the correct temperature.

White oven vent trim piece that frames the ventilation opening. Replace yours if cracked, discolored, or missing to restore a clean finished look.

Fix an oven that won't heat or bake element not working. This relay control board receives signals from the main control board. DIY repair under 1 hour.

This is a Frigidaire oven relay control board. This part is made for the double-oven wall design. The relay control board sends a signal to the main control board, causing the oven to turn on or off. These relay boards are engaged directly by the power button of the unit and the cooking timer. When the relay control board malfunctions or short circuits, the baking and broil functions will be directly affected. The oven may quit powering on altogether if the relay board completely fails. A short in the relay will cause the oven power to function correctly at random times. Wall ovens must be dismounted from their positions to install these parts. Once access is gained to the tear of the stove, the back panel can be removed. The relay control board is located near the bottom of the unit, close to the utility drawer. Unplug the connecting wires and engage the mounting clips holding the board. Discard the old unit, and replace it with the upgrade. Connect the cables and fasten the metal panel on the rear of the oven. Check for proper function before mounting the stove back into the wall.This is a genuine OEM product and is obtained directly from the manufacturer. This part is only compatible with Frigidaire wall ovens.

Snap-in support plate for ovens. Secures internal components in place. Replace if cracked, broken, or missing to restore proper mounting and stability.

Cork and rubber spacer for ovens and ranges. Provides cushioning and spacing between components. Replace if worn, cracked, compressed, or missing.

Hex flange nut with 10-32 thread secures components in appliances. Replace if stripped, missing, or damaged. Flange provides broader bearing surface.

Oven door seal tape creates an airtight barrier to prevent heat loss and improve efficiency. Replace if worn, cracked, or heat escapes. Verify fit with your model.

Cork and rubber spacer for ovens and ranges. Provides cushioning and spacing between components. Replace if worn, cracked, compressed, or missing.

Cushioned fastener washer that protects surfaces and reduces vibration. Replace if cracked, compressed, or missing to prevent metal damage and loosening.

Oval-head square-drive screw secures interior and exterior oven panels, brackets, and trim. Replace worn, stripped, or missing screws for secure assembly.

10-24 x 1/2 inch machine screw that secures temperature probe and thermistor brackets to cooktop, oven, and range chassis. Replace if missing or stripped.

Adhesive seal tape restores tight door seals on ovens, reducing air leaks and improving temperature control. Replace when worn or damaged. Confirm fit.

Replacement #8 x 0.500 inch screw for securing panels, trim, and brackets in appliances. Needed when original fasteners are stripped, lost, or missing.

Specs: 8 - 18 x 0.500

This truss-head machine screw secures a switch to its mounting bracket or panel. Replacing a worn or missing screw restores a solid, aligned switch fit for reliable operation.

• Fastens the switch body to a bracket or chassis panel
• Helps keep the switch aligned for consistent actuation
• Replaces stripped, corroded, or missing mounting hardware
• Common symptoms: loose or wobbly switch, misalignment, rattling or vibration around the switch area

• Disconnect power to the appliance before servicing
• Start threads by hand to avoid cross-threading; tighten snugly without overtightening
• Verify thread size and length match the original hardware
• If multiple screws secure the switch, replace them in a consistent pattern to maintain alignment