Parts for Frigidaire FEC30C4ABC: 03 - Control Panel Parts

Range indicator light illuminates to show when burners or oven are on. Replace if light is dim, flickering, or burned out. Verify fit with your model.

The Control Knob is an OEM part for Frigidaire ranges and ovens. It allows users to set and adjust the temperature and cooking modes on the appliance. This knob is designed for easy grip and precise control, ensuring accurate operation of the range or oven.

Causes of a bad control knob can include wear and tear from frequent use, physical damage such as cracks or breaks, or loosening over time, which can affect its ability to stay securely in place and function properly.

Symptoms of a bad control knob include:

• The knob becoming loose or not staying in place
• Difficulty in turning the knob to set the desired temperature or mode
• The knob being cracked or broken
• Inaccurate temperature settings due to knob malfunction

This OEM replacement is also compatible with Electrolux, Gibson, Kelvinator, and Kenmore models.

Protects and diffuses your range's indicator light that signals when burners are on or surfaces are hot. Replace if cracked or missing. Easy install.

If your cooktop burner won't heat, stays on high, or won't turn off, a faulty burner control switch is often the cause. DIY repair in 15-30 minutes.

Burner won't turn on or heat properly? This range burner control switch restores heat level adjustment. Moderate DIY with wiring terminal labels.

Replacement machine screw used to secure appliance panels and internal components, restoring a stable fit and reducing rattling. Matches a 10-32 thread with a 17/32-inch length for original fastener locations. What it does:

• Fastens panels, trim pieces, and internal brackets; a missing or damaged screw can cause loose panels or rattling noises.
• Secures knobs, control housings and small assemblies to prevent wobble or misalignment.
• Restores proper fit for components so doors and access panels sit evenly and function reliably.

• Disconnect power (unplug or shut off circuit) before accessing components.
• Use the correct driver and tighten by hand; avoid overtightening to prevent stripped threads or cracked plastic.
• Keep any original washers or clips and reinstall them with the screw.

Bushing that centers and supports the control shaft on rotary switches. Replace if cracked, worn, or missing to restore proper knob alignment.