Parts for Ge DDE7200SBLWH: 01 - Section1 Parts

Installation instructions and care guide manual for your dryer. Provides setup procedures, operating guidelines, and maintenance information.

This PM sheet is a small preventive maintenance manual insert that provides basic care and service guidance to help owners keep their appliance in good working order. It offers concise maintenance tips and safety reminders. What it does:

• Summarizes routine maintenance tasks and recommended care steps
• Highlights common symptoms that indicate routine service may be needed
• Provides safety cautions and handling reminders for service technicians and owners
• Helps document performed maintenance for reference during future service

• One printed PM sheet (mini manual) as shown

• No special tools required; place or store the sheet with the appliance documentation per manufacturer instructions
• Keep the sheet dry and legible; replace if damaged or missing
• Follow all safety warnings on the sheet before performing any service
• Dispose of old or damaged sheets according to local regulations

Mounting plate for dryers. Secures internal components in place. Replace if cracked, bent, broken, or missing to restore proper structural support.

Ground clip secures electrical grounding wire in dryers. Replace if loose, corroded, or missing to ensure safe appliance operation. Confirm fit with model.

Color: black. Measures about 1-3/4 inches in diameter. For white order WH1X2721.

The Knob Clip is an OEM part for GE washing machines and dryers. This small but crucial component is designed to secure the control knob to the appliance's control panel.  

Over time, knob clips can wear out or break due to frequent use or accidental damage. When this happens, the control knob may become loose, fall off easily, or fail to engage the control panel properly, making it difficult to set the appliance to the desired cycle or function.

Symptoms of a bad Knob Clip include:

• The control knob is loose or falls off the panel easily.
• Difficulty in adjusting settings due to a loose knob.
• The knob does not stay in place or slips when turned.

This OEM GE part is also compatible with Hotpoint, RCA, and some Kenmore models.

Fix a dryer that won't start or has a broken start knob. This rotary start switch is located in the control panel. Easy 5-10 minute DIY repair.

Dryer won't advance cycles or shuts off at wrong times? A faulty timer is usually the cause. This control restores proper cycle timing and progression.

Replace missing or stripped mounting screws in your refrigerator. This 12-pack of 8-32 thread screws secures panels, brackets, and components.

Black hex washer screw for securing range components like door trim, control panels, and internal brackets. Replace missing or stripped screws during repairs.