Parts for Generac 006240-0: Control Panel Parts

This part is an ATO fuse for air conditioners and generators. A fuse breaks the circuit in the event that there is a fault in the machine that results in too much current to flow. It protects the machine from damage, and will burn out when activated. It may also break due to exposure to the elements.A new fuse may be needed if there is a gap in the wire or if there is darkness inside where the fuse has burned due to an overload. The user can also use a multimeter to measure the resistance of the fuse element to determine if it has gone bad. If the fuse is replaced and immediately goes bad, additional diagnostics should be done to determine the cause.The ATO fuse is a genuine OEM part from the manufacturer and is sold individually. This fuse is compatible with air conditioners and generators that are manufactured by the Generac and Carrier brands.

This is a replacement eye hasp designed to hold the control module in place on generators. The eye hasp connects the back of the control module to the body of the generator and holds it in place with a bolt that fits through the eye. Because this part does not move, it will suffer from only minor wear and tear. The primary risk is from rust due to exposure to the elements. If the eye hasp becomes severely rusted or is damaged or lost when removing the control panel, it will need to be replaced.Replacing the eye hasp is not difficult, but will require the removal of the entire control panel from the generator. Once the module has been removed, locate the mounting point where the hasp attaches to the control module and remove the hasp. Install the replacement hasp and then reattach the control module to the generator body.This genuine OEM part is manufactured by Generac and fits several portable generators the company makes. It is sold individually.

This is a control box assembly that is used in both tillers and snowblowers by major manufacturers. The assembly comes with the lever and the control cable. The purpose of the control box assembly is to engage the self-propel drive. If the cable or other individual components of the control box are damaged, the entire assembly will need to be replaced.To replace the control box assembly, a wrench set, pliers, and a screwdriver may be needed. Turn off the tool and unplug it for safety before making the replacement. Take apart the tool to gain access to the control box assembly. It can be removed from the machine so the new part can be installed. Make sure to reassemble any parts that were taken off before testing the tool. After testing, the tiller or snowblower can be used as normal.This control box assembly is a genuine OEM replacement part that is sourced directly from the manufacturer. The component is made for use on snowblowers and tillers made by Cub Cadet, Craftsman, Toro, and Tecumseh. The component is sold on an individual basis.

This part is a replacement tri LED display. This part's intended use is to replace a broken or defective tri LED display in generators.This part is important for safe and proper equipment usage and thus should be kept in good working condition. If broken, cracked, faulty, or burnt out, this part will need to be immediately replaced with a genuine OEM replacement part. When working on or near an engine, it is important to ensure that it is powered off and completely cool before beginning any repairs.This is an authentic OEM replacement part from Generac made of high-quality materials. This tri LED display can be used with different models of generators that have been manufactured by Generac, Siemens, Honeywell, and some other brands. It is sold individually.

This is a control box gasket that can be used with generators. The gasket is an important part of the control box, as it will help to provide a barrier that ensures foreign objects and debris do not get into the box, where they could cause harm. Check the gasket regularly to see whether it may need to be replaced. It is often better to replace the gasket before it fully breaks down, just to ensure no debris gets inside.Over time, gaskets of all types start to wear down. This is true of the control box gasket, as well. It might crack and pull away. The repair is relatively simple.This control box gasket is compatible with a variety of machines from Generac. It is a genuine OEM replacement part that has been sourced from the manufacturer, and it is sold individually.