Parts for Ge ZGU366NT2SS: Control Panel Parts

Shoulder screw for ranges and ovens. Secures internal components and panels. Order a replacement if your original screw is stripped, missing, or damaged.

Mounting screw hardware for ranges and cooktops. Replace missing, stripped, or corroded screws used to secure panels, brackets, or components.

This stainless steel control panel trim restores the finished look around your appliance's control area and helps protect the controls from spills, splashes, and everyday wear. It matches OEM fit and finish for a clean, factory appearance. What it does:

• Replaces a scratched, dented or bent control panel bezel to improve appearance
• Protects the control cluster from spills and light impact
• Keeps buttons and display edges properly framed to maintain normal operation
• Fits around the control area to restore proper alignment and sealing

• Disconnect the appliance from power (and gas, if applicable) before starting any repair
• Basic hand tools are typically required; access usually gained by removing the control panel or outer cabinet trim
• Handle the bezel carefully to avoid scratching the finish during install
• If mounting hardware or clips are damaged, replace them with OEM parts for a secure fit

Stainless steel #8-18 x 3/8" screw secures panels, brackets, and components in ranges, cooktops, and ovens. Replace if stripped, missing, or corroded.

Replacement mounting screw that secures the thermostat assembly to your range cabinet. Replace if stripped, missing, or damaged during repair work.

This wiring harness provides the factory-style electrical connections between the appliance control and its components, restoring reliable signal and power routing for proper operation. What it does:

• Routes power and control signals between the main control and connected components
• Replaces damaged, frayed, or corroded wiring that can cause intermittent operation
• Helps stop symptoms like components not powering on, intermittent cycles, or blown fuses
• Restores secure connector mating to reduce arcing and poor contacts

• One factory-style wiring harness with attached connectors as shown

• Disconnect all power (unplug or shut off breaker) before starting work
• Compare the part to the original to confirm connector types and wire lengths before installing
• Route and secure the harness following the appliance's wiring channels; avoid contact with sharp edges or moving parts