Parts for Jenn-Air JER8854BCS: 02 - Control Panel Parts

Replacement mounting screws for wall oven and range panels. Secures trim, covers, and internal components. Needed when screws are stripped, missing, or lost.

Replacement mounting screw for washer drum baffles. Secures baffles to drum interior. Order if original screw is stripped, lost, or corroded during repair.

Genuine replacement screw secures panels, brackets, and assemblies in your range. Replace stripped, rusted, or missing hardware to restore solid fit.

Burner won't turn off or only heats on high? This infinite switch controls heat settings for your electric range's surface element. DIY repair.

Fix a burner stuck on high or an indicator light that won't turn off. This infinite switch controls heat settings on electric range burners. DIY-friendly repair.

Indicator light that illuminates when functions are active on your range control panel. Replace if stuck on, dim, or fails to light. Verify fit by model number.

Indicator light lens covers the pilot lamp opening on your range control panel. Replace when cracked, discolored, or missing to restore visibility.

Replacement mounting screw for securing range panels, brackets, and internal components. Replace missing, stripped, or rusted screws to restore fit.

Black door handle mounting screw for ovens and ranges. Replaces missing, stripped, or damaged screws that secure oven or broiler handle trim to door.

Replacement mounting screw for securing range panels, brackets, and internal components. Replace missing, stripped, or rusted screws to restore fit.

Replacement mounting screw for securing range panels, brackets, and internal components. Replace missing, stripped, or rusted screws to restore fit.

Range indicator light assembly illuminates control panel displays. Replace when light fails or flickers. Verify fit with your model number.

26-inch fluorescent lamp for range lighting. Replace when flickering, dim, or not staying lit. Verify your model compatibility before ordering.

Fixes ovens that won't heat or show F8/F9 error codes. This relay switches power to heating elements and fans. Moderate DIY repair with multimeter.

This main wiring harness routes power and control signals between the appliance control board and key components so the unit can operate reliably. Replacing a damaged harness restores proper electrical connections and circuit routing. What it does:

• Carries power and control signals between the main control board and motors, valves, lights and sensors.
• Replaces damaged, burnt, or broken wires that can cause intermittent operation or component failures.
• Common symptom: appliance won't start or certain functions (lights, dispenser, motor) do not respond.
• Also used when connectors are corroded, pins are bent, or wire insulation is compromised.

• One main wiring harness as shown.

• Disconnect power (unplug or shut off breaker) before starting any work to avoid shock.
• Match connector shapes and wire routing; secure harness with clips or ties and avoid contact with sharp edges.
• Inspect connectors and mating sockets for damage; test function after reinstalling and restoring power.