Parts for Kenmore 417.24182300 (41724182300, 417 24182300): Control Panel Parts

Dissolves odor-causing residue and mildew buildup in washing machine tubs. Use every 30 washes to maintain freshness. Verify fit with your model.

This is a small plastic latch that secures the detergent or fabric softener dispenser drawer in the closed position on a front-load washer. It clicks into place to hold the drawer shut during the wash cycle and prevent leaks. Replace this latch if the dispenser drawer won't stay closed, pops open during operation, or the latch tab is cracked or broken.

Suspension spring for washer drum support system. Replaces worn, stretched, or broken springs that cause excessive vibration or drum movement during cycles.

This is the handle attached to the detergent dispenser drawer on a front-load washing machine. It allows you to pull the dispenser drawer open to add detergent, bleach, or fabric softener. Replace this handle if it is cracked, broken, or if the drawer is difficult to grip and pull out.

Washer pilot light bulb illuminates control panel indicators. Replace when indicator lights dim or fail to show cycle status. Verify fit with your model.

Replacement timer mounting screw for washers. Secures the timer assembly to the control panel. Needed when original screw is stripped, missing, or damaged.

Drive rod that connects the agitator to the transmission system in top-load washers. Replace if bent, broken, or worn to restore proper agitator movement.

Pan head mounting screw for dryers. Secures internal components and panels. Replace if stripped, missing, or damaged during appliance maintenance.

Replace your washer's timer dial if the original is cracked, broken, or missing. This control knob installs on the control panel for cycle selection.

Dissolves odor-causing residue and mildew buildup in washing machine tubs. Use every 30 washes to maintain freshness. Verify fit with your model.

Secures hoses to pumps, tubs, and valves preventing leaks. Replace if worn, loose, or causing drips during cycles. Confirm fit with your model number.

This is a rubber hose that connects the detergent or fabric softener dispenser to the wash tub, allowing dispensed products to flow into the drum during the wash cycle. Over time this hose can crack, clog, or develop leaks. Replace it if you notice detergent not reaching the tub, water leaking near the dispenser area, or visible deterioration of the hose.

This factory 8-18 screw secures appliance panels, brackets, and components. Replace missing or stripped hardware to restore a tight, rattle-free assembly and dependable operation.

• Fastens components to frames, brackets, and covers
• Replaces missing, damaged, or rusted screws
• Helps reduce looseness, vibration, and rattling noises
• Restores proper alignment of panels and assemblies

• Disconnect power before servicing; shut off gas/water if applicable
• Start the screw by hand to avoid cross-threading; use the proper driver
• Tighten snugly—do not overtighten to prevent stripping metal or plastic

Suspension bushing for washer tub assembly. Replaces worn, cracked, or missing bushings that cause excessive noise or tub movement during cycles.

This wiring harness connects refrigerator electrical components, restoring reliable power and signal paths between controls and components. It replaces a damaged or worn cable assembly to help stop intermittent or failed operation. What it does:

• Transfers power and control signals between the control board, sensors, and components
• Replaces frayed, burnt, or broken wiring that can cause intermittent operation or component failure
• Helps resolve symptoms such as no power to a component, erratic operation, or circuits that trip
• Maintains factory routing and connector fit for correct electrical connections

• Always disconnect power before starting—risk of electrical shock
• Verify connector orientation and routing to avoid interference with moving parts
• Inspect mounting clips and retainers; replace if damaged to prevent chafing

Rubber isolator that cushions vibrating components in your washer. Replace if cracked, worn, or missing to restore proper mounting and reduce noise.

Dissolves odor-causing residue and mildew buildup in washing machine tubs. Use every 30 washes to maintain freshness. Verify fit with your model.