Parts for Kenmore 587.15173400 (58715173400, 587 15173400): Control Panel Parts

Dissolves limescale, mineral deposits, and odor-causing residues from dishwasher tub and spray system. Use monthly to maintain peak cleaning performance.

6 - 10 x 3/8, pan plask, switch

Includes actuator

Includes actuator

Mounting screw for dishwasher assembly. Secures internal components and panels. Replace if missing, stripped, or corroded during maintenance or repair.

Dissolves limescale, mineral deposits, and odor-causing residues from dishwasher tub and spray system. Use monthly to maintain peak cleaning performance.

This replacement Energy Guide label restores the factory energy-rating label so your appliance displays required efficiency info and model details clearly. It's a direct cosmetic/identification replacement for a missing, faded, or damaged label. What it does:

• Replaces a torn, faded, or missing Energy Guide sticker so energy-use info and ratings are visible
• Restores factory identification and the printed efficiency/consumption information
• Helps meet labeling requirements for resale or service identification
• Provides the original look and placement when applied in the correct location

• One adhesive Energy Guide label

• Surface must be clean, dry, and free of oils or residue before applying
• Align carefully and press firmly; smooth from center outward to avoid bubbles
• Intended as a cosmetic/identification replacement only; does not affect appliance operation
• If label area is textured or damaged, consider a smooth restoration first for proper adhesion

Dishwasher installation instructions and care guide manual. Replace lost, damaged, or missing documentation for proper setup and maintenance reference.

This thermistor is the dishwasher's temperature sensor. It reports water temperature to the control so the heater and cycle timing are managed correctly, helping restore reliable wash performance and more consistent drying.

• Monitors water temperature in the tub/sump and sends readings to the control board
• Helps the control regulate heater operation and determine cycle progress/timing
• Failure can result in no heat or poor drying
• May cause unusually long/short cycles or temperature-related fault codes

• Disconnect power at the breaker and shut off the water supply before servicing
• Access is typically from the toe-kick/base area or sump; remove the lower access panel as needed
• Release the locking tab/clip, remove the sensor, and ensure the existing seal/O-ring is properly seated; install the new sensor fully to prevent leaks
• Reconnect the wire harness, restore power, and run a test cycle to check for leaks and proper heating

Dissolves limescale, mineral deposits, and odor-causing residues from dishwasher tub and spray system. Use monthly to maintain peak cleaning performance.