Parts for Kenmore 587.16074200 (58716074200, 587 16074200): Control Panel Parts

Dissolves limescale, mineral deposits, and odor-causing residues from dishwasher tub and spray system. Use monthly to maintain peak cleaning performance.

6 - 10 x 3/8, pan plask, switch

Includes actuator

Dissolves limescale, mineral deposits, and odor-causing residues from dishwasher tub and spray system. Use monthly to maintain peak cleaning performance.

Includes actuator

This is a replacement screw that comes fitted with a foam washer to secure panels and components while cushioning and sealing the fastened area. It helps maintain a snug, vibration-resistant connection and reduces air or moisture intrusion at the screwpoint. What it does:

• Fastens panels, trim, or components while the foam washer cushions and seals the joint
• Helps prevent rattle and vibration-related noise from loose panels
• Limits air or moisture entry at the screw hole to protect internal components
• Restores proper fit where a worn or missing screw/washer causes gaps

• Use the correct-sized driver to avoid stripping the screw head
• Hand-start the screw and tighten until snug; avoid over-tightening which can compress or damage the foam washer
• Replace any damaged foam washers to keep the seal effective
• Unplug the appliance before servicing

Phillips head mounting screw for dishwashers and ranges. Secures internal components and panels. Replace if stripped, rusted, or missing during repairs.

Dishwasher installation instructions and care guide manual. Replace lost, damaged, or missing documentation for proper setup and maintenance reference.

Owner's manual for your dishwasher. Provides operating instructions, maintenance guidelines, and care information. Replace if lost or damaged.

This thermistor is the dishwasher's temperature sensor. It reports water temperature to the control so the heater and cycle timing are managed correctly, helping restore reliable wash performance and more consistent drying.

• Monitors water temperature in the tub/sump and sends readings to the control board
• Helps the control regulate heater operation and determine cycle progress/timing
• Failure can result in no heat or poor drying
• May cause unusually long/short cycles or temperature-related fault codes

• Disconnect power at the breaker and shut off the water supply before servicing
• Access is typically from the toe-kick/base area or sump; remove the lower access panel as needed
• Release the locking tab/clip, remove the sensor, and ensure the existing seal/O-ring is properly seated; install the new sensor fully to prevent leaks
• Reconnect the wire harness, restore power, and run a test cycle to check for leaks and proper heating

Dissolves limescale, mineral deposits, and odor-causing residues from dishwasher tub and spray system. Use monthly to maintain peak cleaning performance.