Parts for Kenmore 791.734898 (791734898, 791 734898): Control Panel Parts

This part has been discontinued by the manufacturer and is no longer available.

This right-side end cap is a replacement trim piece that secures and finishes the outer edge of the appliance door/frame, restoring appearance and helping keep the door components aligned for smooth operation. What it does:

• Covers and protects the outer edge of the door/frame and internal components from dirt and damage
• Holds adjacent trim and seals in proper position to reduce gaps and rubbing
• Restores factory appearance where a cracked or missing end cap left an exposed edge
• Helps prevent minor snagging when opening or closing the door

• Disconnect power to the appliance before starting any repair
• Removal/installation typically requires light prying or removing a few trim screws; use non-marring tools to avoid damage
• Align tabs or slots and press/secure the cap until it snaps into place; verify even fit along the edge
• If sealing or alignment issues persist after installation, check adjacent trim and fasteners for wear or damage

Decorative nut for gas range exterior trim. Secures cosmetic panels and trim pieces. Replace if lost, stripped, or corroded for a clean finish.

This part has been discontinued by the manufacturer and is no longer available.

Range door latch shield that covers and protects the top latch mechanism. Replace if cracked, broken, or missing to restore proper door alignment.

This part has been discontinued by the manufacturer and is no longer available.

This part has been discontinued by the manufacturer and is no longer available.

Protective wire shield for gas range safety valve. Replaces cracked, damaged, or missing guards. Installs over valve wiring for safety and protection.

This adhesive identification label replaces a torn, faded or missing appliance sticker so model, serial or safety information is legible again. It helps you confirm appliance details for service, parts or safety checks. What it does:

• Restores readable model/serial and specification information that is printed on the original sticker
• Replaces damaged or faded identification and safety labels
• Makes it easier to verify the correct part or service information before repair
• Helps meet safety and inspection needs by restoring visible manufacturer info

• One adhesive identification label

• Clean and dry the mounting area before applying to ensure good adhesion
• Peel backing and press label firmly; hold for several seconds to set
• Avoid placing on textured or insulated foam surfaces where adhesion may be poor

This part has been discontinued by the manufacturer and is no longer available.

This part has been discontinued by the manufacturer and is no longer available.

Sound dampening insulation for gas ranges. Installs inside the range cavity to reduce noise and provide thermal protection. Replace if worn, torn, or missing.